Vermont Castings TrimWorks 36DVBGTKCB User manual

Georgian Bay 36/41”
Installation Instructions
Models:
36DVBGTKCB, 36DVBGTKB
41DVBGTKCB, 41DVBGTKB
DVBGTKCB – Classic Black Cast Iron
DVBGTKB – Ebony Black Enameled Cast Iron
The Georgian Bay is designed for use on fireplace mod-
els 36XDV (36”), DV360 (41”) and DVRT41 (41”).
NOTE: Cast iron parts can be heavy, an assistant
would be advisable for this installation.
CAUTION: Porcelain enamel is fragile. The finish can
be easily damaged if castings are not handled carefully.
Always place castings on a protective surface, such as
a towel, blanket or carpet.
Check Contents of Shipping Carton
Compare contents of carton in Figure 1 with actual
parts received. If any parts are missing, or damaged,
contact your local dealer before starting installation.
Contents: (Fig. 1) Top Dome Section, Main Body Sec-
tion, knob extensions (2), Top Heat Deflector, Screws (4)
Tools required: Phillips screwdriver, measuring tape
NOTE: It is our recommendation that you
install the Georgian Trim, if purchased, be-
fore you install the Georgian Bay. This will
help reduce damage to both cast units.
Fireplace Unit Preparation
Before you start your bay installation the fireplace unit
needs to have some items removed. (Fig. 2)
1. Remove the top louvre by gently sliding the louvre
upward and away from the unit.
2. Remove the sheet metal top flange located on the
bottom side of the top louvre opening. You will need
to remove between 2-5 Phillips screws that are hold-
ing the flange in place.
3. Remove the bottom louvre by removing 4 Phillips
screws or by pulling the hair pins that are holding the
hinge pins in place on the unit.



Top Flange
Top
Louvre
Bottom
Louvre
KT696
Fig. 2 Remove the fireplace top and bottom louvre and top
flange.
4. Install the top heat deflector shield by aligning the
holes of the shield with the four (4) inside holes on
the fireplace top flange. Use the four (4) screws sup-
plied to attach the shield to the unit. (Fig. 3)
This completes the fireplace unit preparation.
30003743 5/08 Rev. 1



Top Dome
Section
Main Body
Section
CAR191
Fig. 1 Carton contents.
Knob Extensions
Screws
Top Heat
Deflector

230003743



Top Edge
of Glass
Frame
Assembly
KT697
Fig. 4 Place main body section of bay on top edge of glass
frame assembly.



Main Body
Section
Measure
Here
Finished
Floor
KT698
Fig. 5 Measure from underside of bay to finished floor.
4. Loosen the 8 screws on the bottom flange, but do
not remove, and lower the bottom flange down by
the amount you measured minus 1/16”. Retighten
screws. (Fig. 6)
Example: 1” - 1/16” = 15/16”
(15/16” is the amount to move flange down)
5. Place the main body section back onto fireplace
unit. Make sure the unit is resting on the top surface
of the glass frame and not the finished floor. If it is
resting on the finished floor then repeat Steps 3 and
4 so that you have a 1/16” gap between the bottom
flange and the finished floor.



Loosen Screws
KT699
Fig. 6 Loosen screws to adjust bottom flange.



Top Heat Deflector
Shield
KT744
Fig. 3 Install top heat deflector shield.
Installation Instructions
1. Place the main body section of the bay onto the
fireplace unit so the flanged edge of the bay rests on
top of the glass frame assembly. (Fig 4)
2. Measure the underside of the bay to the finished
floor. (Fig. 5) This measurement will be used when
adjusting the bottom flange.
3. Carefully remove the main body section and place
face down on a protective surface.

3
30003743
6. Place the top dome section onto the main body sec-
tion by lifting the top dome section over the top edge
of the main body section. You will notice on the back
side of the top dome section two slotted grooves
in the sheet metal. These grooves align with the
flanged brackets on top of the main body section.
Gently slide the top dome section into place and
allow the flanged brackets to slip into the grooves on
the back side of the top dome section. (Fig. 7)
7. Install the two extension knobs supplied onto the gas
valve appropriate knobs.
8. Installation is complete.



Top Dome Section
Slotted Groove
Main
Body
Section
Flanged
Bracket
KT700
Slotted
Groove
Flanged
Bracket
Fig. 7 Lift and slide top dome section over top edge of main
body section and onto brackets.
1
2
3
4
56
7
8
9
9
10
10
11
12
14
15
17
17
18
18
19
22
25
28
27
16
20
20



CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time,
without notice.
Georgian Bay 36”/41”

430003743
2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3
800-668-5323 • www.cfmcorp.com
CFM Corporation
Georgian Bay 36”/41” (continued)
36DVBGTKCB 41DVBGTKCB 36DVBGTKB 41DVBGTKB
Ref. Description Classic Black Classic Black Ebony Ebony
1. Eyebrow, Left 30003718 30003764 30003780 30003792
2. Eyebrow, Right 30003719 30003765 30003781 30003793
3. Frame, Left Dome 30003720 30003766 30003782 30003794
4. Frame, Right Dome 30003721 30003767 30003783 30003795
5. Frame, Left Upper 30003726 30003768 30003784 30003796
6. Frame, Right Upper 30003727 30003769 30003785 30003797
7. Frame, Left Upper 30003728 30003770 30003786 30003798
8. Frame, Right Lower 30003729 30003771 30003787 30003799
9. Door 30003730 30003730 30003788 30003788
10. Panel, Side 30003731 30003731 30003789 30003789
11. Handle, Right 30003755 30003755 30003790 30003790
12. Handle, Left 30003756 30003756 30003791 30003791
13. Door Pin 30003722 30003722 30003722 30003722
14. Bottom Flange, Bay Frm. 30003732 30003772 30003732 30003772
15. Flange, Top Assembly 30003757 30003773 30003757 30003773
16. Dome Flange, Bay 30003744 30003775 30003744 30003775
17. Screen, Door Assembly 30003734 30003734 30003734 30003734
18. Screen, Side Panel 30003739 30003739 30003739 30003739
19. Screen, Center Section 30003740 30003776 30003740 30003776
20. Screen, Dome 30003741 30003777 30003741 30003777
21. Bracket, Screen 30003763 30003763 30003763 30003763
22. Deflector 30003911 30003918 30003911 30003918
23. Magnet 1408818 1408818 1408818 1408818
24. Bracket, Front 30000305 30000305 30000305 30000305
25. Valve Shield 30004025 30004024 30004025 30004024
26. Damper Tabs 1601488 1601488 1601488 1601488
27. Knob, Extension, Hi/Lo 55162 55162 55162 55162
28. Knob, Extension, On/Off 55163 55163 55163 55163