VIBIA I.Cono User manual

SUPPLIED MATERIAL
TECHNICAL SPECIFICATIONS
I.Cono
Design by Lievore, Altherr, Molina
ASSEMBLY INSTRUCTIONS
VERY IMPORTANT
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION: POUR ÉVITER UN CHOC ÉLECTRIQUE, PRÉSENTER LA LAME LARGE LA FENTE LARGE ET POUSSER JUSQU'AU FOND.
CAUTION: HOT SURFACE. KEEP AWAY FROM CURTAINS AND OTHER COMBUSTIBLE MATERIALS.
ATTENTION: SURFACE CHAUDE. TENIR L'ÉCART DES RIDEAUX FORME ET D'AUTRES MATÉRIAUX COMBUSTIBLES.
DRY LOCATIONS ONLY.
POUR EMPLACEMENTS SECS SEULEMENT.
Version U02
0700-INC 0710-INC
1 G obes 1 un. 1 un.
2 A en key 1 un. 1 un.
3 Shade 1 un. 1 un.
4 Ref ector 1 un. 1 un.
Lighting fixture 1 un. 1 un.
.
0700.
0710.
2.
3.
4.
On
y for references
0
700
-
04
-
INC
0710
-
04
-
INC
1.

ASSEMBLY INSTRUCTIONS
1.
Insta the ref ector (A) using the two screws (B) that were removed from
the body (C).
2. Insta the shade (D) on the body (C) as shown by the arrow, so that the
rib on the body s ides comp ete y into the s ot on the shade (see X detai ).
3. Tighten the inner peg (E) using the supp ied A en key. In this way the
shade wi be fixed in p ace.
BC
A
E
3
1
Maintenance
-Use a s ight y-wet cotton c oth for c eaning.
-In case of ma function or damage, p ease contact the retai er who so d the amp.
C
D
Rib
S ot
DETAIL X
2