Vicon HPOE-100 User manual

HPOE-100
Network Camera Housing
INSTALLATION GUIDE
1. Mounting Configuration and Dimensions
2. Component Description
1
January 2016

3. Power Consumption
D-Fog Heater
Always On (9W)
Heater
15°C On, 25°C Off (10W)
IR LEDs
3W
4. Installation Recommendations
If you plan to install this camera enclosure into a tropical, sea coastal, or an environment where salt
water or corrosive industrial waste water/moist are present, please seal each stainless steel screws
and fittings with a silicon grease compounds. This will help prevent electrolysis to occur and extend
the life span of the camera and housing.
5. Installation
A. Prepare a CAT5e Ethernet cable. Pass it through the waterproofconnectors.
B. You may need to remove the RJ45 connector, and use a crimping tool to connect the
Ethernet wires to an RJ45 connector inside the enclosure. Use an Ethernet cable ofthe
width of 5 ~ 6.5mm.
2
January 2016

C. When done, tighten up the waterproof connectors.
D. Align the buffer pad with the mounting hole at the bottom of the camera
E. Place the mounting plate on top of buffer pad and then secure it to the camera. You may need
adjust its position so that the lens module can flush align with the tempered glass.
F. Secure the camera to the enclosure by securing screws through the keyholeslots.
3
January 2016

G. Connect PoE input to the power unit. Connect a short Ethernet cable between thePoE
output and the Ethernet port on the camera. If using the media converter, connect the
wires to the 12V output on the PSU unit.
H. Connect the day/night signal lines from the IR unit to the relay connectors on the
camera's terminal block. The day/night mode relay connection enables the
synchronization of IR light and the automated day/night switching mechanism onthe
camera.
I. Having the wiring done inside the enclosure, you can install the enclosure bracket to a
preferred location at your installation site. Drill mounting holes and a cable routing hole(if
preferred) on a wall. Install the bracket.
J. Lift the whole enclosure up to the installation position, and pass the Ethernetcable
through the bracket.
PoEINfrom
external
PoEOUTto
12VDCOUT
12Vpowertothe
4

K. Mount the enclosure on to the installed bracket, and secure the connection bytightening
the 4 socket screws. Due to the weight of the enclosure, it is best to have two men
mounting the enclosure.
January 2016
5

Vicon Industries Ltd
www.vicon-security.com
6
January 2016