Viking Professional VEOS100TSS User manual

F20297E EN (012809J)
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
[phone]
For product information,
call 1-888-VIKING1 (845-4641)
or visit the Viking Web site at
vikingrange.com
Viking Installation Guide
Outdoor Built-In Electric Smoker Oven

3
DESCRIPTION VEOS100T1
Overall Width 29-1/2” (74.9 cm)
Overall Height 28-9/16” (72.6 cm)
Overall Depth To edge of door - 25-1/2” (64.8 cm)
To end of handle bracket - 28-3/32” (71.4 cm)
Cutout Width 28-1/2” (72.4 cm)
Cutout Height 28-3/16” (71.6 cm)
Cutout Depth 24-1/2” (62.2 cm)
Electrical 120V/60 Hz, 30 amp; 4 ft. (121.9 cm) 3-wire cord with grounded 3-prong plug
Requirements
Maximum Amp Usage 1950 watts 17.7 amps
Smoker Element Rating 300 watts 2.7 amps
Cook Element Rating 2 elements - 750 watts each 6.8 amps each
Oven Interior Width 23” (58.4 cm)
Oven Interior Height 14-7/8” (37.8 cm)
Oven Interior Depth 15-15/16” (40.5 cm)
Oven Interior Overall Size 3.2 cu. ft. .
Approximate Shipping 260 lbs. (117.0 kg)
Weight
SPECIFICATIONS-ELECTRIC SMOKER OVEN
OVEN CUTOUT DIMENSIONS
IN WALL CABINET
24-1/2”
(62.2 cm)
28-1/2”
(72.4 cm)
4”
(10.2 cm)
5” Min.
(12.7 cm)
17”
(43.2 cm)
Junction
Box
Location
28-3/16”
(71.6 cm)
IMPORTANT: PLEASE READ AND FOLLOW
1. Before beginning, please read these instructions completely and carefully.
2. Do not remove permanently affixed labels, warnings, or plates from product. This may void the warranty.
3. Please observe all local and national codes and ordinances.
4. Please ensure that this product is properly grounded.
5. The installer should leave these instructions with the consumer who should retain for local inspector’s use
and for future reference.
Installation must conform with local codes or in the absence of codes, the National Electrical Code, ANSI/NFPA 70 -
latest edition.
IN CANADA:Installation must be in accordance with the current CSA C22.1 Canadian Electrical Codes Part 1 and/or
local codes.
GENERAL INFORMATION
1. WARNING:The use of cabinets for storage above the appliance may result in potential fire or burn hazard.
2. WARNING:This appliance shall not be used for space heating. This information is based on safety
considerations.
3. All openings in the wall behind the appliance in the floor under the appliance shall be sealed.
4. Keep appliance area clear and free from combustible materials, gasoline, and other flammable vapors.
5. Disconnect the electric supply to the appliance before servicing.
6. When removing oven for service and/or cleaning
A. Disconnect AC power supply.
B. Carefully remove the oven by pulling outward. CAUTION: Oven is heavy, use care in handling.
7. Electrical requirements:
Listed in specifications chart p. 5 under Electrical Requirements.
8. The misuse of the oven doors (e.g. leaning on them) can result in possible hazards and/or injuries.
2
WARNING!!
ELECTRICAL GROUNDING INSTRUCTIONS
This electric smoker oven must be electrically grounded in accordance with local codes. This unit is equipped with a
three-prong plug for your protection against shock hazard and should be plugged directly into a properly grounded
three-prong receptacle. Do not cut or remove the grounding prong from this plug.
FOR PERSONAL SAFETY, THIS UNIT MUST BE PROPERLY GROUNDED. DO NOT USE AN EXTENSION CORD
WITH THIS APPLIANCE. SUCH USE MAY RESULT IN A FIRE, ELECTRICAL SHOCK OR OTHER PERSONAL
INJURY.

OVEN DIMENSIONS
FRONT VIEW
29-1/2”
(74.9 cm)
28 9/16”
(72.6 cm)
TOP VIEW
28-1/4”
(73.0 cm)
SIDE VIEW
24-1/32”
(61.0 cm)
25-1/2”
(64.8 cm)
27-7/8”
(70.8 cm)
28-3/32”
(71.4 cm)
UNDERCOUNTER
24 1/2”
(62.2 cm)
4 3/4” Min.
(12.1 cm)
5” Min.
(12.7 cm)
4”
(10.2 cm)
Junction
Box
Location
28-1/2”
(72.4 cm)
28-3/16”
(71.6 cm)
To fasten unit to cabinet:
1. Remove the screws holding
the top trim.
2. Remove top trim to gain
access to screw openings.
3. Attach the unit to the cabinet
using the three screws
provided in locations shown.
4. Replace top trim and screws.
Top Trim and screws
(3) Screws to attach
unit to cabinet
5
4

6
FINAL PREPARATION
1. Some stainless steel parts may have a plastic protective wrap which must be peeled off. All stainless steel body
parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material. If build-up
occurs, do not use steel wool, abrasive cloths, cleaners, or powders!! If it is necessary to scrape stainless steel to
remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or nylon scraper.
Do not use a metal knife, spatula, or any other metal tool to scrape stainless steel! Scratches are almost
impossible to remove.
2. The interior of the oven should be washed thoroughly with hot, soapy water to remove film residues and any
installation dust or debris before being used for food preparation, then rinsed and wiped dry. Solutions stronger
than soap and water are rarely needed.
REPLACEMENT PARTS
Only authorized replacement parts may be used in performing service on the smoker oven. Do not repair or replace
any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a
qualified technician.
Smoke Exhaust/Cooling Air Outlet
Cooling Air Flow
90o
28”
(71.1 cm)
7