Viking LDB-3 Installation and operating instructions

Deactivating the
LDB-3 with a
Remote Switch
October 9, 2003
Deactivate the LDB-3 Relay with
a Remote Switch
T
TE
EL LE EC CO OM MS
SO
OL LU UT TI IO ON NS SF FO OR RT TH HE E2
21 1S
ST TC
CE
EN NT TU UR RY Y
APPLICATION
APPLICATION
N
No ot te e
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or
subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate
such changes.
Fax Back Doc 866 Rev 2Printed in the U.S.A.
P
Pr ro od du uc ct tS Su up pp po or rt tL Li in ne e. .. .. .7 71 15 5. .3 38 86 6. .8 86 66 66 6F Fa ax xB Ba ac ck kL Li in ne e. .. .. .7 71 15 5. .3 38 86 6. .4 43 34 45 5
The internal relay on the LDB-3 can be manually deactivated
from a remote switch, contact closure, etc. This can be use-
ful to turn off the controlled device (strobe light, camera, etc.)
If the relay has been activated by ringing the switch will deac-
tivate the relay and ringing must stop for a minimum of 6 sec-
onds before the relay can be reactivated from a new incom-
ing call.
P
Ph ho on ne e. .. .. .7 71 15 5. .3 38 86 6. .8 88 86 61 1
h
ht tt tp p: :/ // /w ww ww w. .v vi ik ki in ng ge el le ec ct tr ro on ni ic cs s. .c co om m
I
In ns st ta al ll la at ti io on n
i
in nf fo o@ @v vi ik ki in ng ge el le ec ct tr ro on ni ic cs s. .c co om m
1 2 3 4 5 6 7 8 9 10 11
Z3
Z3
Z2
Z2
R
5
R
2
R4
R4
R7
R7
R9
R9
R8
R8
CR
CR
2
1
2
3
4
5
6
7
8
9
To C.O. Line or Analog
PABX/KSU extension
To Terminal Device/Phone
10
11
Normally Open
Common
Normally Closed
(+) Black
(-) Black with
White Stripe
120V DC
390 Ohm - 750 Ohm, 1/2 Watt Resistor
(Radio Shack part # 271-1114, 271-1115,
271-1116, 271-1117 or equivalent)
Momentary
Switch
Wire a 390 - 750 ohm resistor in series with a momentary switch
connected between terminal postitions 5& 11. Wire a jumper
across terminal positions 6& 10.
Note: This application note is designed to be used in conjunction
with the LDB-3 Technical Practice, Fax Back Document 409.