
Viale Vicenza, 14 - I 36063 Marostica VI
Tel. +39 0424 488 600 - Fax (Italia) +39 0424 488 188 - Fax (Export) +39 0424 488 709
www.vimar.com
02661.120
Instruction sheet
Notice technique
CONNECTIONS
•With management interface art. 01846
WiththeBUSmanagementinterfaceitispossibletocontrolthelightingappliance
withtheBy-mecontrolpanel(integrationoftheemergencylampsintheBy-mesystem).
INSTALLATION
The lighting appliance must be installed 2.5 m off the floor level.
Thelightingapplianceisequippedwithoneselectorpositionedinthebat-
terycompartment(fig.3):
• SELECTOR to ON: operating time 1 h and brightness 100%
• SELECTOR to 1: operating time 3 h and brightness 30%
If it is set to the autonomy of 3 h to apply, according to the markings placed on
the front of the appliance, the labels supplied.
Atthetimeofpurchasethebatteryisnotcompletelychargedandisdisconnectedfrom
thecircuit;beforeconnectingthelightingappliancetothepowersupplymains,toenable
battery.Thenleaveittochargeforatleast12hours.
ToactivatethelightingapplianceinSAmode(permanent,thatisalwayson),connect
theSEandSAterminalstothepowersupplymainsasillustratedinfigure5.Ifthe
system is prepared for the By-me system, connect the bus cable terminal before
installingtheappliance.
Note.Thebatteryissuppliedwithalabelstatingtheyearandweekofproduction(e.g.
0845correspondstothe45thweekof2008).Writethedatewhenthebatteryisput
intoserviceonthelabel.Thebatterymustbereplacedwhenitnolongerassuresthe
declaredoperatingtime(theledcannotbereplaced).
INSTALLATION RULES
Installationshouldbecarriedoutincompliancewiththecurrentregulationsregarding
theinstallationofelectricalsystemsinthecountrywheretheproductsareinstalled.
CHANGING THE BATTERY
Thereplacementmust onlybe made by expert personnel. Theappliance contains the
rechargeablebatteryart.00913;beforemakingthereplacementremovethevoltagefrom
thepowersupply.Followthedirectionsoffigure6tomakethereplacement.
CONFORMITY
LVdirective.StandardsEN60598-1,EN60598-2-22,EN60598-2-2,EN62471.
EMCdirective.StandardsEN61547,EN61000-3-2,EN61000-3-3,EN55015.
Theunit02661.120complywiththestandardEN1838.
Photobiological Safety: Risk group 1 (Low risck) in accordance with EN
62471.
USER INFORMATION IN COMPLIANCE WITH EUROPEAN
DIRECTIVE 2002/96 (RAEE).
Inordertopreventdamagetotheenvironmentandhumanhealth
aswellasincurringadministrativesanctions,appliancesbearingthis
symbolmustbedisposedofseparatelyfromurbanwaste,orhanded
intothedistributorwhenbuyinganewone.Appliancesmarkedwith
theabovesymbolmustbecollectedinconformitywiththeinstructions
issuedbythelocalauthoritiesinchargeofwastedisposal.
FRANÇAIS
Appareil d’éclairage de secours autonome avec LED haute efficacité, 120 V~ 50-60
Hz, batterie rechargeable Ni-Cd et support incorporé pour l’installation en boîtes
d’encastrement 6/7 modules. À compléter avec la plaque 7 modules Eikon ou Plana.
CARATTERISTICHE
•Tensiond’alimentation:120V~±10%50-60Hz
•Ledàhauteefficacitéblanche,températuredecouleurde5000K(min)à6300K(max).
•Absorption:5W
•BatterierechargeableauNiCd4,8V800mAh
•Tempsderechargebatterie:12heures
•Autonomie:1hou3h(sélectionnable)
•Fluxlumineuxenurgence:75lmavecautonomie1het27lmavecautonomie3h
•Corpsauto-extinguible
•Lalampenepeutêtrecommandéeparrégulateur(dimmer)
•Degrédeprotection:IP40(IP20àl’intérieurdecloisonscreuses)
•AppareilsdeclasseII
•Installablesursurfacesnormalementinflammables
•LEDverteetLEDrougepoursignalisationfonctionnementnormaletprésenceanomalies
•Dispositifderechargedesbatteriesàcourantconstant
•Dispositifdeprotectioncontreladéchargeexcessivedelabatterie
FONCTIONNEMENT
État de l’appa-
reil d’éclairage
LED
verte
LED
rouge Remarques
Présencetension
d’alimentationet
batterieenchargée
Allumée
xe
Éteinte Courantdemaintien
Batterie en
recharge
Clignotante Éteinte Chargerapide
Anomalie Éteinte Allumée
xe
Pannegénéraledel’appa-
reild’éclairage
Batterieà
remplacer
Éteinte Clignotante Labatterienegarantit
plusl’autonomiedéclarée
BRANCHEMENTS
•Avec interface de gestion art. 01846
Aumoyen del’interfacede gestionBUS,il estpossiblede commanderl’appareil
d’éclairageenutilisantlacentraleBy-me(intégrationdeslampesdesecoursdans
l’installationBy-me).
INSTALLATION
L’appareil d’éclairage doit être installé à 2,5 m du plan de piétinement.
L’appareild’éclairageestéquipédeunsélecteurpositionnédanslelogementbatterie(fig.3):
• SÉLECTEUR à ON: autonomie 1 h et luminosité 100%
• SÉLECTEUR à 1: autonomie 3 h et luminosité 30%.
Si elle est définie à l’autonomie de 3 h à appliquer, selon les marques placées
sur la face avant de l’appareil, les étiquettes fournies.
Au moment de l’achat, la batterie n’est pas complètement chargée et est décon-
nectéeducircuit;avantderelierl’appareild’éclairageauréseaud’alimentation,valider
lefonctionnementdelabatterie.Lalaisserenchargependantaumoins12heures.
Pourmettrel’appareild’éclairageenmodalitéSA(permanentetoujoursallumée),relier
lesbornesSEetSAauréseaud’alimentationcommeillustrésurlafigure5.Sil’on
prédisposel’installation pourle système By-me, relierla borne du câblebus avant
d’installerl’appareil.
Note.Labatterieestfournieavecuneétiquettesurlaquellesontindiquéesl’annéeet
lasemainedefabrication(ex.0845correspondàla45èmesemainedel’année2008).
Appliquersurl’étiquetteladated’entréeenservicedelabatterie.Labatterieoutout
l’appareil d’éclairage doivent être remplacés lorsqu’ils n’assurent plus l’autonomie
déclarée(leledn’estpasremplaçable).
RÈGLES D’INSTALLATION
L’installationdoitêtreeffectuéedanslerespectdesdispositionsquirégissentl’in-
stallationdumatérielélectriqueenvigueurdanslepaysd’installationdesproduits.
REMPLACEMENT DE LA BATTERIE
Leremplacementdoitêtreeffectuéuniquementpardupersonnelcompétent.L’appareil
contientunebatterierechargeableart.00913;avantd’effectuerleremplacementretirerla
tensiondel’alimentationélectrique.Suivrelesindicationsdelafigure6poureffectuerle
remplacement.
CONFORMITÉ AUX NORMES
DirectiveBT.NormesEN60598-1,EN60598-2-22,EN60598-2-2,EN62471.
DirectiveEMC.NormesEN61547,EN61000-3-2,EN61000-3-3,EN55015.
Leunité02661.120seconformeràlanormeEN1838.
Photobiologie sécurité: Groupe de risque 1 (Faible risque) en respect
norme EN 62471.