Vinotemp VT-21-TEDS2Z User manual

VT-21TEDS-2Z
VT-21TEDS-2Z, replacing the Temperature Display Board
Open the wine cooler door, you will find two screw caps on the temperature display board
Then use a screwdriver to gently open the screw cap
You will find a hole
Also open the other screw cap

In the two holes, there are two screws
Use a screwdriver to open the left screw
Then open the right screw
Now the display board will separate from the wine cooler

On the left and right side, you will find some wires and wire connections. There are two different types of boards that will
both work. The picture below will show you the two boards and the two types of wiring connections.
Disconnect the wiring connections.
Note: if your board has the connections on it then carefully remove the connection from the board.
Take out the temperature display board from the wine cooler

See the back of the temperature display board
There are four screws, use a screwdriver to open them
Now take out the display board from the box

Then put the new display board on the box
Now place the static prevention film back on.
Put the screw’s back on
Connect the temperature display wire from two sides

Place the wire and connection back into its housing. Please be careful not to crimp the wire.
Put the panel on the wine cooler according to the screw place
Put on the left and right screw
Put screw caps back on.
A new temperature display board is now installed