Vintage view W Series User manual

W Series Base Plate
W Series Frame Base Plate (FCF-BASE) Installation Instructions
• (1) FCF-BASE • Phillips Head Driver / Drill Level
• Metal Cutting Saw
• Tape Measure
• Metal File
• Pencil
Starter Kit Included Parts Required Tools
1. Measure height of area
Measure the overall height W Series Wine Rack Frame
installation area. Subtract 1/8 inch (thickness of the
FCF-BASE) from the measurement and mark both legs
of the W Series Frame with the resulting dimension. Be
sure to measure and mark away from the attached base
plate to leave it intact.
2. Cut the frame
Using a metal cutting saw, squarely cut both legs of
the W Series Frame to length and remove any result-
ing burrs with a metal file.
Pro-Tip: Abrasive cut-off saws should NOT be used
for this operation, as the heat generated will likely
damage the finish of the FCF-HD. Instead, use a
portable band saw, reciprocating saw, or hack saw
to make the cuts.
Figure A
Figure B

Instructions: FCF-BASE
3. Insert the Base Plate
Slide the Base Plate into the newly cut end of the W
Series Frame and use this end as the top of the frame.
4. Finish the assembly of the W Series Wine
Rack Frame and install using instructions included
with Frame.
Figure C