Vitalograph 4000 User manual

= Bad blow
1
1
Set FEV₁ Personal Best
Test Result
Perform Test
View Parameters
Review History
Lung Monitor
Guide for Healthcare Professionals
B Increase FEV₁
3
B or C Review History
3
E Set FEV₁ Best
E Return
Note: Zone boundaries 95% and 90%
4
4
D Switch On
1
D Switch On
1
C + B hold for 3 seconds
2
E Hold for 3 seconds
2
Press
E to show best test
4
Insert disposable mouthpiece
1Demonstrate to test subject
v Fully breathe in, hold...
v Insert and lightly bite the mouthpiece
v Then blow as
hard as possible
for 6 seconds
2Repeat blow 2 more times 3
D For 3s to switch off
4
Normal
Arrow always
show best blow...
Display shows FEV₁ and % of PB
Displays numbers for each blow until
E pressed ...
1
Below
Normal
Arrow always
show best blow...
Press
B to show FEV₆
2
Below 90%
of PB
Arrow always
show best blow...
Press
B to show FEV₁ /FEV₆ ratio
3

1D Switch On
1C+ B + E Hold for 10 seconds 2D Switch Off 3
1D Switch On
1
H www.vitalograph.co.uk I
1
Delete History
Modify Other Zones
Modify Green Zone
Default Zone Settings
D Switch On
1C + E
Hold for 10 seconds
2
Press
E to show best test
4
E+ B Hold for 3 seconds
2Repeat blow 2 more times 3
Cleaning and disinfecting
The outer surfaces should be cleaned every week, more often if necessary. The
use of a disposable disinfecting wipe is recommended, with special attention
to the mouthpiece area.
15014_4
E Set Mid Boundary
8
B or C
Lower Boundary
5B or C Mid Boundary
7
E Set Lower Boundary
6
Note: 3-Zones now set.
Press
E E to exit or for 4-Zones...