metal and positions the device a minimum of 15mm from the
Unlicensed transmitter
Class B digital device or peripheral
This device complies with part 15 of the FCC Rules .Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
Information to user
Caution: Changes or modifications not expressly approved by
the vivo Mobile Communication Co.,Ltd. could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Consult the dealer or an experienced radio/TV technician for
help.
SAR statement
This device meets the government's requirements for exposure
to radio waves.
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set
by the Federal Communications Commission of the U.S.
Government.
The SAR limit set by the FCC is 1.6W/Kg. For body-worn
operation, this device has been tested and meets the FCC RF
exposure guidelines for use with an accessory that contains no
body. RF exposure compliance with any body-worn accessory
that contains metal was not tested and certified, and use of
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
FCC SAR
Head ：W/kg
Body-worn：W/kg（15mm distance）
Hotspot：W/kg（10mm distance）
such body-worn accessory should be avoided. Accessory
available in market and must be used to keep use distance
15mm from EUT to body-worn operation.
vivo 1935
Quick Start Guide
Please read this Quick Start Guide before using your
phone, and keep it for future reference.
1.1710.607
1.086
