Vivo STAND-TV65A User manual

Black Easel Studio TV Stand
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
Instruction Manual
https://vivo-us.com/products/stand-tv65a
SKU: STAND-TV65A
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
PACKAGE CONTENTS
WARNING!
A (x2)
Leg
B(x1)
Center Leg
C(x1)
Lower VESA
Bracket
J (x2)
ST4.2x12
K x1)
2mm Allen
Wrench
L(x1)
4mm Allen
Wrench
I(x2)
Cable Clip
E (x1)
Pole
F (x1)
Steel Cable
G (x2)
Security Clip
H (x2)
Security
Clip Clamp
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
NOTE: SOME HARDWARE INCLUDED MAY NOT BE USED
M-F (x4)
Square
Washer
M-G (x8)
Small Spacer
M-E (x4)
M8x50
M-A (x4)
M5x14
M-B (x4)
M6x14
M-D (x4)
M8x30
M-H (x8)
Big Spacer
M-C (x4)
M6x30
N(x4)
Anchor
M (x4)
ST4.8x38
D(x1)
Upper VESA
Bracket
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
• NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF TV OR STAND.
• USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.

3
ASSEMBLY STEPS
STEP 1
Screw side legs (A) and center leg (B) into base of pole (E).
TOOLS NEEDED
Phillips
Screwdriver
STEP 2
Adjust collar height using the 4mm Allen wrench (L).
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
70.4lbs
(32 kg)
Drill
A
A
B
E
L
NORMAL FLOOR
55 lbs
(25 kg)
GLOSSY FLOOR
NOTE: Please secure the locking
collar before attaching the TV
screen.
Recommended 50-150mm

4
STEP 3
Remove screw from center clamp of lower VESA bracket (C) and open the clamp.
STEP 4
OPTION A: Flat Back Monitor
Position VESA brackets horizontally on the back of the TV, making sure upper bracket
(D) is on top and lower bracket (C) is below. Secure using screws (M-A or M-B) with
square washers (M-F), with security clips (G) installed to top holes.
C
C
D
M- B
G
M- F
M- A
G
M- F
M- F
M- A
M- F
M- B

5
STEP 4 (Continued)
OPTION B: Large or Curved Back Monitor
Position VESA brackets horizontally on the back of the TV, making sure upper bracket
(D) is on top and lower bracket (C) is below. Secure using screws (M-C, M-D or M-E)
with square washers (M-F) and spacers (M-G, M-H) with security clips (G) installed to
top holes.
M- G
M- C
M- D
G
M- F
M- H
M- C
M- D
G
M- F
M- G
M- H
M- C
M- D
G
M- F
M- H
M- E
G
M- F
M- H
M- E
G
M- F M- G
M- H
M- E
G
M- F
M- G
M- C
M- D
M- F
M- G
M- C
M- D
M- F
M- H
M- C
M- D
M- F
M- G
M- H
M- E
M- F
M- H
M- E
M- F
M- H
M- G
M- E
M- F
M- H
M- G
C
D

6
STEP 5
Slide the TV with VESA brackets (C, D) onto pole (E). Close the clamp on lower VESA
bracket over the pole and secure with previously removed screw.
1
3
2
J
1
2
3
I
STEP 6
Peel backing from cable clips (I) and install clips on rear leg. Use clips to organize cables.
Optional: Secure cable clips using ST4.2x12 screws (J). Screws are able to thread directly into wood
without drilling pilot holes.

7
STEP 7
Adjust TV to desired height, making
sure the bottom edge of the TV does not
contact the base of the pole.
a
±180°
1100mm
STEP 8
Using Security Cable Clamps (H) as guides, mark drilling locations on wall. Drill holes at least 1.6”
(40mm) deep using a 9/32” (7mm) drill bit. Insert anchors (N) into holes and mount clamps to wall
using ST4.8x38 screws (M). Thread steel cable (F) through security clips on TV and center holes in
cable clamps as shown, then tighten clamps using the 2mm Allen wrench (K).
2
1
1100-1350mm
H
400-650mm
M
NG
F
K
F

LAST UPDATED: 06/02/2020
Open Monday - Friday 7:00am - 7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times. If any
parts are received damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
[email protected] AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
AVG. RESOLUTION TIME (within oice hrs): < 15 M
www.vivo-us.com
Chat live with an agent!
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
309-278-5303