Assembly Steps
2
- Pre Assemble t e Pole Set
Remove the grub screws by provided Allen Key
(o). Connect the poles (a) by threads as below
diagram. Install the grub screws and fasten them
by provided Allen Key (o).
Step 1: Install Pole to Desktop
Install the “C”-Clamp Brace (c) to the Pole (a) using M x14 Bolts (f),
and tighten using the Allen Key (o). Install the “C”-Clamp (b) to the
pole assembly according to the thickness of the desktop. The
thickness can be changed to three positions. Connect it using 2pcs
M8x12 Bolts (g), and tighten using the Allen Key (o). Tighten the “C”-
Clamp to the desktop using the plastic knob.
Option A: Desk Clamp Install
Position the Pole (a) on the mounting
surface and mark the center hole. Drill a
3/8" (10mm) diameter hole at the marked
position through the mounting surface.
Install the Grommet Base Plate (m) to the
Pole (a) using M x14 Bolts (f). Position
the Pole (a) on the mounting surface and
secure using the Support Plate (j), M10
Washer (k), Spring Washer (l) and M10
Bolt (i). Fasten the M10 Bolt using
provided Wrench (p).
Step 1 (Continued)
Option C: Grommet Base Installation
If the existing grommet hole comes with a plastic
protector, remove it to ensure a flat surface before
installing the desk mount. Install the Grommet Base
Plate (m) to the Pole (a) using M x14 Bolts (f).
Position the Pole (a) on the mounting surface and
secure using the Support Plate (j), M10 Washer (k),
Spring Washer (l) and M10 Bolt (i). Fasten the M10
Bolt using provided Wrench (p).
Option B: Existing Grommet Base Installation
