VMP LCD-MID-FT User manual

For more information, please contact us at:
325 Log Canoe Circle, Stevensville, Maryland 21666
(T) 410.643.6390 / (F) 410.643.6615
www.videomount.com
VIDEO MOUNT PRODUCTS
Instruction Sheet For:
LCD-MID-FT & LCD-MID-FTB

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before at-
tempting to assemble the mount.
Step 2
Mark the wall or desired mounting surface in preparation of installa-
tion of the wall plate . Pre-drill in necessary and mount the wall
plate to the desired mounting surface.
Warning: Please verify that your mounting surface will support the
combined weight of your mount, mounting hardware, and moni-
tor. Also verify that the mounting surface is safe to drill through. If in
doubt, please contact a professional installer.
Step 3
Determine the correct screw size and if you need to use washers,
lock washers, or spacers. Note: Spacers are used for TVs with re-
cessed hole patterns. Secure the display to the screen mount brack-
et using the appropriate hardware through . Note:
The brackets have to be level with each other to work properly.
Step 2: Mounting the wall plate
(Lag screws are not included)
Step 3A: Attaching the mounting
brackets to the screen
(spacers not needed)
Step 3B: Attaching the mounting
brackets to the screen
(spacers used due to recessed
hole patterns)
VIDEO MOUNT PRODUCTS
1
25
11
3
1

Step 4: Adjusting the tilt tension
before placing the screen on
the wall
Step 4
Adjust the tilt tension by tightening the socket head screws with
the M5 Allen Key so they are fairly tight. Note: You may have
to adjust the tilt tension once the flat screen is on the wall so do not
tighten as hard as you can because it will make further adjustment
on the wall much more difficult.
Step 5
Use the hooks on the pivot bracket to hook on the top rail of the
wall plate . Use the M5 screws to secure the TV to the wall
plate and to secure its horizontal position.
Step 6
If you need to adjust the tilt tension:
Tilt down the flat screen as far as it will go. Note: This is done to give
you room to work with behind the flat screen. Take the M5 Allen Key
and tighten down the socket screws until you have
achieved the desired tilt tension and readjust the tilt to the desired
angle.
Please verify that all nuts and screws are securely tightened.
Step 5: Securing the pivot
brackets to the wall plate
Step 6: Adjusting the tilt tension
after placing the screen
on the wall
WARNING: The installer of these products must verify that the mount-
ing surface, ceiling or wall, will safely support the combined weight
of all attached equipment and hardware. Video Mount Products will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
4
9
1
2
1
10
4
10
VIDEO MOUNT PRODUCTS