Step1
Before starting, lay out all parts to your mount and match them to the
parts list provided. Verify that you have all your parts before attempt-
ing to assemble the mount.
Step 2
Mark the wall or desired mounting surface in preparation of installa-
tion of wall plate . Pre-drill if necessary and mount wall plate to
desired surface. Make sure the mounting hardware just loose enough
that you can slide the LCD-FT out using the keyhole slots cut into the
wall plate . Warning: Please verify that your mounting surface will
support the combined weight of your mount, mounting hardware, and
monitor. Also verify that the mounting surface is safe to drill through. If
in doubt, please contact a professional installer.
Step 3
Take the LCD-FT off the wall by sliding the mount up until you can use
the keyholes to free the wall plate of the mounting hardware. Then
mount the mounting plate to the back of the monitor using the M4
or M5 screws provided with the LCD-FT. Note: Make sure the top
of the keyholes are pointing to the top of the monitor. Place the LCD-FT
back on the wall using the keyholes slots.
Step 4
To adjust tilt adjustment tension simple take a Philips head screw driv-
er and tighten or loosen the top M6 screw on each side to desired
tension.
Please verify that all nuts and screws are securely tightened.
Step 2: Attaching the wall
plate to the wall
(Lag screws are not included)
Step 3: Attaching your monitor
to a mounting plate
VIDEO MOUNT PRODUCTS
Step 4: Adjusting the tilt
adjustment tension
WARNING: The installer of these products must verify that the mount-
ing surface, ceiling or wall, will safely support the combined weight
of all attached equipment and hardware. Video Mount roducts will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
1
1
1
6
5
4
21
