VMP LCD-2537C User manual

For more information, please contact us at:
325 Log Canoe Circle, Stevensville, Maryland 21666
(T) 410.643.6390 / (F) 410.643.6615
www.videomount.com
VIDEO MOUNT PRODUCTS
Instruction Sheet For:
LCD-2537C & LCD-2537CB

Step1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before at-
tempting to assemble the mount.
Step 2
Determine which VESA standard plate you will be using or
(75mm/100mm or 200mm/100mmx200mm respectively) and at-
tach the selected mounting plate or to the swivel bracket
using the M6 screw and the nylon nut . (Set this assembly
safely to the side for now.)
Step 3
Mark the ceiling or desired mounting surface in preparation of in-
stallation of wall mounting plate . Pre-drill if necessary and mount
wall plate to desired surface. Mount wall plate with small welded
rotation stoppers to the bottom of the plate. Warning: Please verify
that your mounting surface will support the combined weight of your
mount, mounting hardware, and monitor. Also verify that the mount-
ing surface is safe to drill through. If in doubt, please contact a pro-
fessional installer.
Step 4
Attach the swivel bracket assembly from step 2 to the support tube
using the 3/8” screw , washers and nylon nut . Insert
adjustable screw into the back of the swivel bracket for use
when tilting the monitor.
Step 2: Attaching the mounting
plate to the pivot bracket
Step 3: Attaching the ceiling plate
to the ceiling.
(Lag Screws not included)
Step 4: Attaching the swivel
bracket to the support tube.
VIDEO MOUNT PRODUCTS
1
1
4
83 15
16
12
5
6
56
97
4

Step 5
Attach the support tube to the extension tube using the 3/4”
screw and washers .
Step 6
Attach the mounting plate assembly from step 2 to your LCD moni-
tor using the M4 or M5 screws or as appropriate.
Step 7
Attach the extension tube to the ceiling plate using the
5/16” screw and nylon nut . Secure the 3/4” screw from
slipping in the extension tube by tightening the ¼” brake screw
into the threaded hole in the side of the extension tube using
the Allen key .
Step 8
Insert end plugs into the support tube . For cable manage-
ment, insert the cable clips by pushing the arrow ends into the
square holes in the support tube . Please verify that all nuts and
screws are securely tightened.
Step 5: Attaching the support
tube to the extension tube
Step 6: Attaching the monitor
to the mounting plate
Step 7 : Connecting the exten-
sion tube to the ceiling plate
WARNING: The installer of these products must verify that the mount-
ing surface, ceiling or wall, will safely support the combined weight
of all attached equipment and hardware. Video Mount roducts will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
32
11
1
2
2
17
18 19 10
2
21 22
3
10
20
14
3
13