Volvo 31285224 User manual

Instruction No Version Part. No.
30756311 1.4 31285224
Navigation system, portable
IMG-279567
Instruction No Version Part. No.
30756311 1.4 31285224
Navigation system, portable
IMG-279567
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 1 / 71

Equipment
A0000162 IMG-246925 IMG-239667 IMG-239660 IMG-239681 IMG-240673
IMG-239942 IMG-240675 IMG-282403
IMG-279568
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 2 / 71

IMG-213320
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 3 / 71

INTRODUCTION
Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to
minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available
before starting installation.
Certain steps in the instructions are only presented in the form
of images. Explanatory text is also given for more complicated
steps.
In the event of any problems with the instructions or the
accessory, contact your local Volvo dealer.
Note!
For information about the GARMIN unit refer to:
www.garmin.com.
Note!
Sections 1-66 apply to cars without loudspeaker grilles.
Sections 67-134 apply to cars with loudspeaker grilles.
The disc marked A in the kit is used on cars with loudspeaker
grilles.
Some steps in these installation instructions are presented
with illustration only.
Applies to cars without loudspeaker grilles
1
IMG-296185
Applies to cars without loudspeaker grilles
Assembling the holder
Note!
Take care when handling the components, they are fragile and
are easily damaged.
Take the three bolts M5x30 part.no. 986958 and nuts out of the
kit.
In order to avoid too much resistance when the nuts on the
cradle are tightened, secure the bolt and run the nut on and off
of the thread on the bolt. Do this with all the nuts and bolts.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 4 / 71

2
IMG-282404
Take special tool 9814104 (torx driver, torx 6), and unscrew the
two screws holding the connector in the holder.
Carefully push the connector to one side with the cable to
expose the bottom of the holder.
3
IMG-282405
Take the kit with the four spacers from the installation kit.
Carefully pry off the spacer 31212788. The part number (1) is on
the bottom of the spacer.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 5 / 71

4
IMG-282407
Take the three screws and insert them in the spacer fully.
5
IMG-282408
Apply pieces of butyl tape to the screws so that the screw heads
do not protrude outside the spacer when installing it.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 6 / 71

6A
IMG-282406
6B
IMG-282409
Install the spacer in the bottom of the holder. Ensure that the
holder's two screw turrets align between the small pins in the
oblong holes in the spacer.
A click should be heard when the spacer is securely in position.
7
IMG-282410
Place the connector in the bottom of the holder so that:
the guide hole (1) in the connector's circuit board aligns in the
corresponding pin at the bottom of the holder
the holes (2) in the circuit board are over the holder's screw
turret.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 7 / 71

8
IMG-282411
Take the small torx screws and carefully tighten the connector to
the holder. Ensure that the connector's circuit board is properly
against the screw turret and that there is no play.
Remove the butyl tape from the screws.
9
IMG-246024
Preparations
Turn the ignition switch to position 0.
Disconnect the battery negative lead.
Note!
Wait at least three minutes before unplugging the connectors
or removing other electrical equipment.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 8 / 71

10
IMG-279845
Take the template from the kit and cut along the outer lines
LHD/RHD
11
IMG-279846
Note!
It is important to carefully measure for the location of the
template. Incorrect positioning of the hole group can cause
problems in tightening the holder.
Apply a piece of tape on the dashboard between the LED and
button for the hazard warning lights, centered in the middle of
these.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 9 / 71

12
IMG-279848
Mark out the middle of the piece of tape in two places as
illustrated, and draw a line between these marks.
13
IMG-279854
Measure a distance of 82 mm (3¼") from the joint between the
dashboard and grille and rearwards on the dashboard.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756311 - V1.4
Page 10 / 71