Volvo 31285223 User manual

Instruction No Version Part. No.
30756306 1.5 31285223, 31285225
Navigation system, portable
IMG-280105
Instruction No Version Part. No.
30756306 1.5 31285223, 31285225
Navigation system, portable
IMG-280105
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 1 / 24

Equipment
A0000162 IMG-282403 IMG-246925 IMG-239660 IMG-239667 IMG-240673
IMG-239681
IMG-280472
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 2 / 24

IMG-280106
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 3 / 24

IMG-213320
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 4 / 24

INTRODUCTION
Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to
minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available
before starting installation.
Certain steps in the instructions are only presented in the form
of images. Explanatory text is also given for more complicated
steps.
In the event of any problems with the instructions or the
accessory, contact your local Volvo dealer.
Note!
For information regarding the GARMIN device, see
www.garmin.com.
Note!
Some steps in these installation instructions are presented
with illustration only.
Assembling the holder
1
IMG-296185
Assembling the holder
Note!
Take care when handling the components, they are fragile and
are easily damaged.
Take the three screws M5x20 part no. 986956 and nuts from the
kit.
To prevent too great resistance when the nut for the holder is
tightened, hold the screw and screw the nut on and off the
threaded part of the screw. Carry this out on all screws and nuts.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 5 / 24

2
IMG-282404
Take special tool 9814104 (torx driver, torx 6), and unscrew the
two screws holding the connector in the holder.
Carefully push the connector to one side with the cable to
expose the bottom of the holder.
3
IMG-282405
Take the kit with the four spacers from the installation kit.
Carefully pry off the spacer using P/N 31212525. The part
number (1) is on the bottom of the spacer.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 6 / 24

4
IMG-282407
Take the three screws and insert them in the spacer fully.
5
IMG-282408
Apply pieces of butyl tape to the screws so that the screw heads
do not protrude outside the spacer when installing it.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 7 / 24

6A
IMG-282406
6B
IMG-282409
Illustration A
Install the spacer in the bottom of the holder.
Illustration B
Ensure that the holder's two screw turrets align between the
small pins in the oblong holes in the spacer. A click should be
heard when the spacer is securely in position.
7
IMG-282410
Place the connector in the bottom of the hole. The guide hole (1)
in the connector's circuit board must align in the corresponding
pin at the bottom of the holder and the holes (2) in the circuit
board must be over the holder's screw turret.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 8 / 24

8
IMG-282411
Take the small torx screws and carefully tighten the connector to
the holder. Ensure that the connector's circuit board is properly
against the screw turret and that there is no play.
Remove the butyl tape from the screws.
Preparations
9
IMG-246024
Preparations
Turn the ignition key to position 0.
Disconnect the battery negative lead.
Note!
Wait at least three minutes before unplugging the connectors
or removing other electrical equipment.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 9 / 24

10
IMG-280165
Applies to cars with automatic gearbox
Turn the ignition key to position II.
Applies to all models
Move the gear selector lever to its rearmost position.
Use a weatherstrip and pry off the gear selector panel at the rear
edge.
11
IMG-239204
Press in the catches and remove the panel.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 10 / 24

12A
IMG-280166
12B
IMG-280133
Illustration A
Remove the two screws.
Remove the bracket with the A/C panel and radio from the
center console. Pull from the lower edge and then downwards
until it releases from the mounting at the upper edge.
Note!
Do not damage the removed components or the surrounding
panels.
Illustration B
Lay out a cloth to protect the tunnel console and unit. Place as
illustrated. Depending on the design the cable may need to be
disconnected and the unit placed to one side.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 11 / 24

13A
IMG-296283
13B
IMG-296284
Illustration A
Remove the loudspeaker grille as follows: Insert the special tool,
9995919 into the joint between the loudspeaker grille and the
dashboard approximately as illustrated, until it engages.
Twist the tool 90° so that the bent section engages with the
underneath of the loudspeaker grille.
Illustration B
Pull upwards until the loudspeaker grille detaches. The
loudspeaker grille is securely fastened by four clips. Move the
tool closer to the clip to facilitate removal.
Note!
Do not damage the dashboard.
Lift out the loudspeaker grille
14
IMG-280107
Take the template from the kit and cut it along the outer lines.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 12 / 24

15
IMG-280108
Tape the template to the loudspeaker grille.
16
IMG-280109
Drilling is the same on right and left-hand drive cars. Drill square
to the loud speaker grille.
Predrill the holes according to the template using a Ø3 mm
(1/8") drill bit.
Remove the template.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 13 / 24

17A
IMG-280112
17B
IMG-280113
Illustrations A and B
Turn over the loudspeaker grille and cut away some of the ribs
on the underside so that the result corresponds with figure B.
18
IMG-280114
Drill up the three holes for the cradle's feet using a Ø14 mm
(9/16") step drill.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 14 / 24

19
IMG-280115
Take the step drill and drill out the hole for the connection in the
holder using a Ø28 mm (1 7/64") drill bit.
20
IMG-280116
Deburr and bend in the edges using a round file.
Installation
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 15 / 24

21A
IMG-280117
21B
IMG-280118
Installation
Illustration A
Take three nuts, washers and the cradle from the kit and secure
on the loudspeaker grille.
Illustration B
Tighten the cradle.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 16 / 24

22A
IMG-280119
22B
IMG-280120
22C
IMG-280121
Illustration A applies to cars up to and including model year
-05
Illustration B applies to cars from and including model year
06-
Remove the five screws. Lift up the loudspeaker and remove the
connector.
Put the loudspeaker to one side. New loudspeaker and console
in the kit.
Illustration C
On vehicles without a center loudspeaker there is a console
holding the loudspeaker grille. On these vehicles the console
remains in place and the cable is routed through the hole.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 17 / 24

23
IMG-277338
Take the cable harness and foam tape out of the kit. Remove the
protective tape.
24
IMG-280122
Wrap the foam tape around the fuse holder to prevent rattling.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 18 / 24

25
IMG-280123
Note!
The cable harness is always routed on the right-hand side in
the tunnel console and the center console up to the hole for
the loudspeaker grille, on both right and left-hand drive cars.
Take hold of the long cable harness. Route the end with the
small connector on the right-hand side in the center console, up
and out through the hole for the loudspeaker grille/console
loudspeaker grille.
26
IMG-280124
Take out the unit with the climate panel and connect connector
(1) removed from the 12V outlet on the female connector (2) on
the routed cable.
Connect the remaining connector to the 12V outlet.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 19 / 24

27
IMG-280125
Applies to cars up to and including model year 05
Remove the loudspeaker grille and loudspeaker from the kit.
Secure the loudspeaker using the supplied screws. The
connections on the speakers should face right.
28A
IMG-280126
28B
IMG-280127
Illustration A applies to cars up to and including model year
-05
Illustration B applies to cars from and including model year
06-
Connect the connector to the loudspeaker. Route the cable to
the cradle through the large hole in the speaker console.
Tighten the console using the five existing screws.
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation Navigation system, portable- 30756306 - V1.5
Page 20 / 24