Vox VISION CREDENZA User manual

Tel [phone]
Tel [phone]
Fax [phone]
mail@nienkämper.com
www.nienkamper.com
VOX VISION®CREDENZA
VOX BOARDROOM CREDENZA
INSTALLATION GUIDE
HEX SOCKET BOLT
4 mm - 1/4" x 20 x 11/4".
For fastening tops to cabinet.
For joining multiple segment cabinets.
SHELF PINS
Inserted into cabinet gable for adjustable
shelf support.
HEX SOCKET BIT - 4 mm
For height adjusting cabinets.
For joining multiple segment cabinets.
For fastening tops to cabinets.
HARDWARE PARTS LIST

12
34
LEVEL CABINETS REMOVING/INSTALLING DRAWERS
ASSEMBLE CABINETS INSTALL TOP
•Position cabinets in desired location.
•Credenzas with adjustable levellers can be easily adjusted from the
interior of the cabinet.
•Using the bit provided, insert through the holes in the base and adjust
up or down as required.
•Drawers may need to be removed to allow access for fastening
cabinets or tops.
•Simply compress the orange slide lock (under the drawer) and lift the
drawer out.
•To replace, position over slides and pull slide forward until locked.
Note: Large credenzas ship in multiple sections.
•Once components have been positioned and levelled, hole locations
will align with thread locations between cabinets.
•Install 1/4" x 20 x 11/4" hex socket bolts.
•Position tops onto credenza.
•Align threaded hole locations with holes in cabinet sub top.
•Install 1/4" x 20 x 11/4" hex socket bolts.

56
78
9
INSTALL ADJUSTABLE SHELVES INSTALLING REFRIGERATOR
EQUIPMENT STORAGE- EQUIPMENT STORAGE-
SLIDING RAIL ROTATING SWING FRAME
•Insert shelf pins in desired location.
•Position shelf in cabinet.
•Install glass shelf stored inside refrigerator before placing in credenza.
•Position refrigerator in opening.
•Pull power cable through the grommet in the back of the cabinet.
•Center and push refrigerator into cabinet.
•To install equipment - remove the plastic locking strip at the base
of the rack.
•Pull the rack out of the cabinet.
•The locking strip may be re-installed to secure equipment.
•Frame can be completely removed by loosening pivot pin and depressing.
•Equipment can be easily installed by rotating swing frame out of the cabinet.
•Loosen thumb screw knob until frame is free.

ATTACHING/REMOVING HINGES
HEIGHT ADJUSTMENT DEPTH ADJUSTMENT
10 11
ADJUSTING DOORS
REMOVING THE COVER PLATE SIDEWAYS ADJUSTMENT
•Gently rotate the door in the direction
shown - then press lightly on the end of
the arm to secure the catch.
•To remove the hinge from the mounting
plate, press gently in the places shown
by the arrows.
•Remove metal cover plate on the hinge by
carefully prying it off with a screwdriver.
•Locate the lugs on the mounting plate into
the recesses beneath the arm.
•Adjusting this screw moves the door sideways to adjust the gap
between doors (minus 0.5 mm to plus 5.0 mm).
•To begin adjusting the door, remove the cover plate from the hinge.
•Cover plates are easily pulled off and replaced without tools.
12 13
•Adjusting this screw moves the door in or out from the cabinet
(minus 0.5 mm to plus 2.8 mm).
•Adjusting this screw moves the door vertically (plus or minus 2.0 mm).
632006
V.1 05/03