VTech Baby Bopping & Cruising Baby Driver User manual

Bopping & Cruising
Baby DriverTM
Instruction Manual

2
INTRODUCTION
Thank you for purchasing the Bopping & Cruising Baby DriverTM!
Put baby in the driver's seat with this exciting driver that attaches to
strollers. Cool car features and interactive dashboard apps are fun to
play with on the oor or on the go.
On/Off/
Volume
Control
Switch
Temperature
Slider
Gear
Shifter
Control
Panel
Buttons
Turn
Signal
Horn Squeaker Mirror
Steering
Wheel

3
INCLUDED IN THE PACKAGE
• Bopping & Cruising Baby DriverTM
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d'utilisation car il comporte
des informations importantes.
WARNING
With the Bopping & Cruising Baby DriverTM safety comes rst. To
ensure your child’s safety, adult assembly is required. Never use the
Bopping & Cruising Baby DriverTM as a handle. Do not use in moving
vehicles. Do not add additional strings or straps. Possible entanglement
or strangulation injury when attached to cribs or playpens/play yards.
Do not attach to cribs or playpens/play yards.
Unlock the packaging locks:
Turn the packaging locks 90 degrees
counterclockwise several times.
Pull out and discard the packaging locks.

4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the unit, use a screwdriver to
loosen the screw, and then open the
battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery
box. (For best performance, alkaline batteries or fully charged
Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

5
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in re.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries (if removable) from toy before
charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.
PRODUCT FEATURES
1. On/Off/Volume Control Switch
To turn the unit On, slide the On/
Off/Volume Control Switch to the
Low volume or High volume
position. You will hear fun sounds, a
phrase and a song. To turn the unit
Off, slide the On/Off/Volume Control
Switch to the Off position.
2. Stroller Attachment
Position the Bopping & Cruising
Baby DriverTM on the stroller bar.
Using the straps on the back of
the toy, fasten each side of the toy
securely to the stroller bar using the
hook and loop closures, ensuring they
are securely fastened.

6
3. Automatic Shut-Off
To preserve battery life, the Bopping & Cruising Baby DriverTM
will automatically shut off after approximately 45 seconds without
input. The unit can be turned on again by activating the electronic
features. Turning the steering wheel will not turn the unit back on.
NOTE
If the unit powers down or if the light fades out during play, please
install a new set of batteries.
ACTIVITIES
1. Steering Wheel
Turn the Steering Wheel to pretend
to drive, you will hear fun car sounds,
friendly phrases and music. The lights
will ash with the sound.
2. Control Panel Buttons
Press one of the six Control Panel
Buttons to learn colors, hear songs,
playful melodies, fun phrases and
sounds related to the button graphics.
The lights will ash with the sound.
3. Gear Shifter
Push or pull the Gear Shifter to learn
about opposites through imaginative
phrases, sounds and short tunes. The
lights will ash with the sound.

7
4. Turn Signal
Slide the Turn Signal lever to hear
realistic car sounds and imaginative
phrases. The lights will ash with the
sound.
5. Temperature Slider
Slide the Temperature Slider to
pretend to choose heating or cooling
mode while driving, hear fun sounds
and phrases. The lights will ash with
the sound.
6. Horn Button
Press the Horn button to hear a fun
squeaking sound.
MELODIES
1. Yankee Doodle
2. Glow Worm
3. Chicago, That Toddlin' Town
4. William Tell Overture
5. The Wheels on the Bus
6. Looby Loo
7. Hickory, Dickory, Dock
8. Funiculi, Funicula
9. Colonel Bogey March
10. A-Tisket, A-Tasket

8
SONG LYRICS
Song 1
Beep, beep!
Wave hello to friends you know.
Beep, beep!
Wave good-bye, it's time to go!
Song 2
Start the car, where should we go?
Turn the wheel, let's go, go, go!
Song 3
Drive through the city,
Drive through the country,
Drive through the forest,
There's lots to see.
Song 4
Red light means it's time to stop,
And yellow means it's time to slow.
Green light means it's time to go.
These are the rules of the road!
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
5. The soft fabric steering wheel and soft pedals are surface
washable only.

9
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please follow
these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and lling out
our Contact Us form located under the Customer Support link.
Creating and developing VTech products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of our
products. However, errors sometimes can occur. It is important for
you to know that we stand behind our products and encourage you
to contact us with any problems and/or suggestions you might have.
A service representative will be happy to help you.

10
NOTE
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.