Wagan MINI STEPPER 2273 User manual

Item No.n°: 2273
MiniStepperMaster™
User’s Manual

Mini Stepper Master™by Wagan Tech®
1
Dear Valued Customer,
Thank you for purchasing Wagan Tech®Mini Stepper Master fitness
equipment! We know you will be more than satisfied with our products. This
user manual contains instructions on how to properly operate and care for
your new Mini Stepper Master.
(7) 2x Handle bars
(6) LCD Meter
(5) Connecting Tube
(1) Power Cable
(8) 4x Long Bolts
(8) 4x Washers
(4) 4x Short Bolts
(4) 4x Lock Washers
(4) 4x Washers
(4) 4x Short Bolts
(4) 4x Lock Washers
(4) 4x Washers
(2) Stand Tube
(3) Main Frame
NOTE:
It is important to
adhere strictly to the
instructions that are
outlined in this manual
for correct operation
and maintenance of
the equipment. We
will not be held liable
for any bodily injury
or property damage
resulting from misuse
of the equipment.
SPECIFICATIONS
•Assembled size:
11.5 x 15.5 x 45.0 in.
•Weight: 27.0 lbs

User’s Manual—Read before using this equipment
2
ASSEMBLY
1. Run the Power Cable (1), located in the tube of the Main Frame (3)*,
through the Stand Tube (2). Be careful not to pull/push the sensor that is
connected to the Power Cable too far in.
2. Connect the Stand Tube (2) to the Main Frame (3) with supplied short bolts
and washers (4).
3. Run the Power Cable (1) through the Connecting Tube (5).
4. Connect the Connecting Tube (5) to the Stand Tube (2) with supplied short
bolts and washers (4).
5. Connect the Power Cable (1) to the underside of the LCD Meter (6)
6. Cap the LCD Meter (6) onto the top of the Connecting Tube (5).
7. Connect the two Handle Bars (7) to either side of the Connecting Tube (5)
with supplied long bolts and washers (8).
*If the cable is not in the main frame, check both the Stand Tube (2) and the Connecting
Tube (5).
MAINTENANCE
• Inspect the Mini Stepper Master thoroughly at regular intervals to check to
see whether there are loose joints, loose hydraulic parts, wobbling pedals
and/or parts that have been damaged or worn out over time.
• Put lubricating oil or grease on hydraulic components of the Mini Stepper
Master and any of its moving parts at 3 month intervals. Applying
lubricating grease may help to minimize noise and to fix uneven or rough
movements of the pedals, should these occur.

Mini Stepper Master™by Wagan Tech®
3
• Store the Mini Stepper Master in a cool and dry environment.
• Do not clean the surface of the Mini Stepper Master with organic solvents
(i.e. gasoline, benzene, etc.) to avoid damaging the equipment’s surfaces.
TENSION ADJUSTMENT
1. Locate the tension knob, which looks like a screw with a triangular cap
(Figure 1).
2. Locate the threaded hole on the backside of the main frame (3), opposite
of the pedals (Figure 2).
Figure 1 Figure 2 Figure 3
3. Twist the tension knob slowly into the threaded hole (Figure 3). As the
tension knob is fastened into the main frame, the amount of force required
to tighten the knob will increase.
4. Tighten the tension knob fully for the initial set up. One side of the stepper
will automatically lift up as the tension knob is screwed into the main
frame. Manually press one pedal all the way down and lift the other
pedal all the way up.
5. Once the tension knob has been inserted fully, test out the workout tracker.
First, reset the display by holding down the red mode button for about 4
seconds, then start stepping on each pedal in an alternating fashion to
make sure the workout tracker is counting.
6. If the tension is too tight or hard, adjust the knob by unscrewing it slightly.
Do not unscrew the tension knob too far out or you may have to repeat
the set-up process.
USING THE MINI STEPPER MASTER
We recommend that you utilize your Mini Stepper Master on a daily basis, for
half an hour at a time. We believe you will feel its marvelous cardio training
effects after one month of use. The Mini Stepper Master is excellent whether

User’s Manual—Read before using this equipment
4
used at home or in the office. For example, even exercising during a break at
work would produce great results. Rather than feeling fatigued or exhausted,
you will feel refreshed and energized with the Mini Stepper Master!
• Persons with hypertension, obesity, and heart disease should not perform
strenuous exercise using the Mini Stepper Master.
• This product is designed only for use by individuals with a weight not
exceeding 225 lbs.
•We suggest that you keep a healthy daily diet; it is strongly encouraged that
you consume sufficient amounts of nutrients in each category of the food
pyramid that is outlined on the U.S. Department of Agriculture’s website.
• We do not recommend that you exercise when feeling exhausted or tired.
•Perform some warm-up exercises prior to your exercise routine to decrease
the risk of injury. For example, stretch your arms, legs, and back.
• Pacing yourself is extremely important. Exercise on the Mini Stepper
Master should be done in a regular, smooth fashion; sudden bursts of
speed are not recommended because they may increase the risk of
physical injury.
HOW TO OPERATE THE DIGITAL TRACKER
Start Start exercising by stepping on the pedals. The
power for the display will automatically turn on and
the counter will start tracking your workout.
Function
selection Press the MODE button until the function you would like to have displayed is selected.
Scan When the display is set on the SCAN function, the workout
tracker will be changed every 5 seconds to display TIME >
CAL > REPS/MIN, then back to TIME again, and so on.
Stop There is no power-off button. Simply stop stepping. The display will
automatically turn off after several minutes (~4 minutes) of inactivity.
Resume If you have stepped away momentarily and would like to resume
your workout session, DO NOT PRESS ANY BUTTONS. Start
stepping again and the display will automatically come on if it has
turned off while you were away. The tracker will pick up where
you left off and continue counting. If you do not want to continue
the last workout session, you will need to reset the tracker.
Reset Hold the MODE button for 3–4 seconds to
have all function values reset to zero.

Mini Stepper Master™by Wagan Tech®
5
MULTI FUNCTION WORKOUT TRACKER
S
T
O
PCOUNT
REPS /MIN
SCAN
TIME
CALORIES
COUNT Steps accumulated since start of
exercise (always visible)
REPS/MIN Repetitions per minute (estimated)
SCAN Cycles between:
TIME > CALORIES > REPS/MIN
TIME Workout duration (Time lapse)
CALORIES Calories burned (estimated)
BATTERY
• The Workout Tracker LCD operates on 1 AAA battery.
• The battery will need to be replaced when an incorrect display appears
on the LCD meter.
Buy quality exrcise & fitness equipment in our online store.