Wali PTT007-B User manual

INSTALLATION MANUAL
1-844-SATTLER (18447288537)
[email protected]
www.walielectric.com
Monitor Stand Riser
PTT007-B
20kg/44lbs
RATED

2
Anti-skid Pad
E(×4)
Cellphone Holder
F(×1)
Caution: Frequently assembling and disassembling may cause damage to the wood board.
Bolt
C(×4)
Sticker
G(×4)
Supplied Parts List
Step 1
Place Board A on a flat surface with bottom upward, insert the Bolt C to the hole on Board A and tighten with a
screwdriver. (Screwdriver not included)
Caution: Please make sure the Bolt C is vertically straight at an 90° angle to the surface of Board A as the image shown.
C
C
A
A
A
C
A
C
ABoard surface
Nut
D(×4)
90° Angle
Bolt
Support Stand
B(×2)
Board
A(×1)

3
Step 2
Attach the Nut D to the hole on Support Stand B as the image shown.
Caution: Please make sure the arrow on the Nut D is pointing upright towards the hole on the Support Stand B
as the image shown.
D
D
DB
B
B
Step 3
Insert Support Stand B to the Bolt C on Board A .
CA
B
B
A
C

Step 4
Tighten the Nut D clockwise to fasten for stability. (Screwdriver not included)
D
Step 5
Insert the Cellphone Holder F to the designated position on Board A .
Notice: The Cellphone Holder F is removable. Push it from the back of the Board A to remove it if necessary.
A
F
B
A
D
Optional Step:
F
FA
A
B
Tear off the Anti-Skid Pad E and Sticker G, attach it to the designated position as the image shown.
EG
A
B
G
E