Walker Edison BU30SEA User manual

Item # : BU30SEA
Assembly Instructions
!/II
{1 II
YII
II
----L
---
 

 
y 
¥
__ II
-
 
 .eredison.com
Revised 04/16/2018
Copyright © 2018, by Walker Edison Furniture Co., LLC. All rights reseed. P.1

Insert wooden dowel (A) and secure cam bolt (D) with screwdriver into part (3,4).
Insert wooden dowel (A) into part (1,6,8).

Secure cam bolt (D) with screwdriver to part (1).
Attach part (1) to part (8) using screw (Q) with screwdriver.

Attach part (3,4) to part (1), then insert and secure cam lock (C) to part (1) to lock it.
Attach part (6) to part (1), then insert and secure cam lock (C) to part (1) to lock it.

Slide back panel (7) into grooves as per diagram.
Attach part (2) to part (3,4,6) using bolt (F) with hex key (R), and screw (Q) with screwdriver.

Attach part (10) to part (1) using screw (P) with screwdriver.
Attach door stopper (N) to part (1) using screw (T) with screwdriver.

Attach part (11) to part (2) using bolt (B) with hex key (R).
Place sticker (E) over holes as per diagram.

Attach plastic wedge (G) to part (7) using screw (H) with screwdriver.
Insert shelf support pin (J) into side panel (3,4).

Place shelf (5) on top of support pin (J).
Attach glass holder (L,M,U) to part (9) with screwdriver.

Place plastic pivot (K) over holes as per diagram.
Place hinge (L) into plastic pivot (K) on part (2). Insert top hinge (L) into plastic pivot (K) on
part (1), then slide the glass door (9) into the bottom hinge (L). Secure door by tightening
door hinge (L,M) screws with equal pressure. Glass doors can be adjusted by carefully
loosening the hinge screws and adjusting the glass placement to optimize door alignment.
Re-tighten the hinge screws.