Walker Edison BU52JOR User manual

Item # : BU52JOR
Assembly Instructions
  
 
Revised 01/2018
Copyright © 2018, by Walker Edison Furniture Co., LLC. All rights reserved. P.1

Insert wooden dowel (A) to bottom panel (2) and part (19). Secure cam bolt (B) to top panel (1).
Insert wooden dowel (A) to shelf (11,12), and side panel (9,10).
Secure cam bolt (B) to shelf (11), and side panel (9,10).

Insert wooden dowel (A) to part (3,4,5,6), and side panel (7,8).
Secure cam bolt (B) to part (3,4,5,6).
Insert side panel (7,8) into part (3,4,5,6), then insert and secure cam lock (C) to side panel (7,8)
to lock it.

Use wrench (E) to secure leg (18) to bottom panel (2) with bolt (D), and secure part (19) to
shelf (11).
Insert shelf (12) into side panel (9,10), then insert and secure cam lock (C) to shelf (12) to lock it.

Slide back panel (13) into grooves as per diagram.
Use wrench (E) to secure bottom panel (2) to side panel (9,10) with bolt (D).

Slide back panel (13) into grooves as per diagram.
Insert side panel (9,10) into shelf (11), then insert and secure cam lock (C) to side panel (9,10)
to lock it.

Slide back panel (14) into grooves as per diagram.
Insert bottom panel (2) and shelf (11) into side panel (7) and part (3,5), then insert and secure
cam lock (C) to bottom panel (2) and shelf (11) to lock it.

Insert bottom panel (2) and shelf (11) into side panel (8) and part (4,6), then insert and secure
cam lock (C) to bottom panel (2) and shelf (11) to lock it.
Insert top panel (1) into part (3,4,5,6,19), then insert and secure cam lock (C) to part (3,4,5,6,19)
to lock it.

Place sticker (L) over holes as per diagram.
Secure plastic wedge (N) to back panel (13,14) with screw (O).

Insert shelf support pin (F) into side panel (7,8,9,10), then place shelf (17) on top of support
pin (F).
Secure bolt (U) to door (15,16), door hinge (J) to door (16) and door hinge (K) to door (15)
with screw (G).

Secure handle (H) to door (15,16) with bolt (I).
Place plastic pivot (M) over holes as per diagram.

Insert door hinge (J,K) into panel hole as per diagram.
Slide door (15,16) onto door hinge (J,K) as shown in diagram and secure it with screw (G).
Place unit in desired location and mark the wall for anchor location. Insert plug (S) into wall as
per diagram.

Secure flat plate (Q) to as shown in diagram with screw (R).
Secure product to wall with screw (T).