Walker Edison DT41 User manual

ITEM#: DT41
Assembly Instructions
  
 
Revised 03/2017
Copyright © 2010, by Walker Edison Furniture Co., LLC. All rights reseed. P.1

Screw cam bolts (B) into top panel (1). Insert dowels (A) into shelf (7). Attach door stopper (D) to top panel (1)
using small screws (E). Attach nylon strap (P) to top panel (1) using small screw (Q).
Screw cam bolts (B) into side panels (3,4).Insert dowels (A) into side panels (3,4).

Attach side panels (3,4) to shelf (7) using cam bolts and dowels as guides. Insert cam locks (C) into
shelf (7) and tighten with a screwdriver.
Attach bottom panel (2) to the assembly from Step 3 using large bolts (F) and wrench (G).

Attach top panel (1) to the assembly from Step 4 using cam bolts and dowels as guides. Insert cam locks (C)
into top panel (1) and tighten with a screwdriver.
Secure back panel (9) to the assembly from Step 5 by gently hammering nails (H) into the assembly at the
points shown above. Note that nylon strap (P) should hang out the back of the assembly.

Insert shelf support pins (I) into the stand assembly at desired shelf heights. Carefully place shelves (8)
onto shelf support pins (I). Note that there will be two shelf support pins on either end of each shelf.
Attach handles (J) to doors (5,6) using medium screws (K). Attach hinges (L) to doors (5,6) using flat-head
screws (M). Screw small bolts (N) into doors (5,6).

Attach doors (5,6) to the assembly from Step 7 using flat-head screws (M) at hinges (L).

Step 11 (Optional)
Walker Edison Furniture Company strongly recommends that this item is attached to a wall to
prevent it from falling over. Due to the wide variety of wall types, the necessary hardware for wall
attachment may not be included. There is included in this package large screw (R) and plug (S) for
use in general wall attachment. To attach the item to a wall, use only hardware that is suitable for
that particular wall type. Several hardware and wall types are illustrated below. Suitable hardware is
available from any hardware store. Please seek professional advice if you are unsure of your ability
to mount this item correctly.
P.10
BACK PANEL
NYLON STRAP
WALL
WOOD SCREW
(NOT INCLUDED)
BACK PANEL
NYLON STRAP
CEMENT WALL
PLUG
CEMENT SCREW & PLUG
(NOT INCLUDED)
BACK PANEL
NYLON STRAP
DRYWALL
DRYWALL ANCHOR SCREW
(NOT INCLUDED)
BACK PANEL
NYLON STRAP
WALL
METAL SCREW
(NOT INCLUDED)
Cement/Brick Wood Studs
Metal Studs
Drywall
POTTENIBAC
POTTENIBAC
CABINET TOP CABINET TOP
WOOD STUD
METAL STUD