Walker Edison DW46AF User manual

A


D




J





Q



倒立
副

～

0

♂






Hardware
List
 
 
 
 
 
 
   
  
   
   
  
  
   
   
    
   
   
   
   
   
。  阻恒d 
  

 

 

  

Step 1
Slider 
S 
S 

S 

Step 2

R
3
  P.5
Disassemble drawer slider (S) by sliding the slider arm and slider bracket apart. Depress
the small lever of the slider bracket and carefully pull the two pieces apart. Repeat this
process for both drawer sliders (S).
Secure drawer slider arms (S) to side panels (7,8) with screw (R).

Secure slider brackets (S) to drawer side panel (14,15) with screw (R).
Secure cam bolt (B) to top panel (1). Insert wooden dowel (A) and secure cam bolt (B) to
back panel (2).

Insert wooden dowel (A) and secure cam bolt (B,K) to side frame (3,4).
Insert wooden dowel (A) to parts (9,10). Secure cam bolt (B) to drawer front panel (12), then
secure handle (E) with bolt (F).

Insert wooden dowel (A) to side panel (7,8) and parts (5,6,17). Secure cam bolt (B) to
parts (5,6).
Insert parts (9,10) into back panel (2) and parts (11), then insert and secure cam lock (C) to
parts (9,10), and use wrench (P) to secure parts (11) to parts (9,10) with bolt (N) to lock them.

Insert parts (5,6) into side panel (7,8), then insert and secure cam lock (C) to side panel
(7,8) to lock it.
Insert side panel (7,8) into back panel (2), then secure it with screw (D).

Insert side frame (3) into back panel (2) and parts (5,11), then insert and secure cam lock
(C) to parts (5), and use wrench (M) to secure back panel (2) and part (11) with half moon
washer (J) and nut (L) to lock them.
Insert side frame (4) into back panel (2) and parts (6,11), then insert and secure cam lock
(C) to parts (6), and use wrench (M) to secure back panel (2) and parts (11) with half moon
washer (J) and nut (L) to lock them.

13
Insert top panel (1) into desk frame, then insert and secure cam lock (C) to back panel (2),
side frame (3,4), side panel (7,8), and parts (5,6) to lock it.
Insert parts (17) into drawer back panel (13) then secure it with screw (D). Secure drawer
side panel (14,15) to drawer back panel (13) with screw (D). Slide drawer bottom panels (16)
into grooves as per diagram.

Insert drawer front panel (12) into drawer side panel (14,15) and parts (17), then insert and
secure cam lock (C) to drawer side panel (14,15) and parts (17) to lock it.
Place sticker (G) and plastic cover (Q) over holes as per diagram.

Step 17
S 
〉／
 
S 
s
Step 18
Final Assembly
  
Press down/up the slider lock on slider bracket, then insert the drawer into slider arm to
lock it.