Walker Edison HT72FIN User manual

Item# : HT72FIN
Assembly Instructions
  
 

    P.1

Disassemble drawer slider (T) by sliding the slider arm and slider bracket apart. Depress
the small lever of the slider bracket and carefully pull the two pieces apart. Repeat this process
for both drawer sliders (T).
Secure drawer slider brackets (T) to drawer panel (12, 13) and drawer slider arms (T) to side
panels (5, 6) with screw (Q).

Insert wooden dowel (A) to side panel (5,6,7). Secure cam bolt (B) to drawer front panel (15)
and seat panel (9).
Insert side panel (5,6,7) to bottom panel (4), then use wrench (K) to secure them with bolt (E).

Slide back panel (8) into grooves as per diagram.
Place seat panel (9) onto side panel (5,6,7), then insert and secure cam lock (C) to side panel
(5,6,7) to lock it.

Secure plastic wedge (G) to back panel (8) with screw (F).
Disassemble two bolts attached in hook (S), then secure hook (S) to panel (10) as per diagram.

Use wrench (K) to secure bottom frame (3) to bottom panel (4) with bolt (H).
Use wrench (K) to secure bottom frame (3) to side frame (1,2) with bolt ( ).
I

Use wrench (K) to secure panel (10) to side frame (1,2) with bolt (J) and nut (L).
Secure drawer side panel (12,13) to drawer back panel (11) with screw (R).

Slide drawer bottom panel (14) into grooves as per diagram.
Mount drawer front panel (15) to drawer side panel (12,13), then insert and secure cam lock (C)
to drawer side panel (12,13) to lock it.

Place sticker (D) over holes as per diagram.

Press down/up on the lock on the slider bracket, then insert the drawer into the slider arm to
lock it.

Place unit in desired location and mark the wall for anchor location. Insert plug (N) into wall
as per diagram.
Secure side frame (1,2) to plug in wall with screw (M) and washer (O), to secure product to wall.