Walker's RAZOR XV User manual

RAZOR XV with Bluetooth® (GWP-NHE-BT)
DEVICE FUNCTIONS
•Turning the device on:
Press and hold the Power button for 2 seconds
The very first time the device is turned on, the Ambient Volume setting is Sound Level 5 (+3dB).
•Changing Ambient Sound Volume:
Volume changes respectively when pressing the Ambient Volume Up or Down controls:
▪Volume Up increases volume by one stage.
▪Volume Down decreases volume by one stage.
When Sound Level Changes a single audible beep is produced as an indicator.
•When Ambient Volume reaches minimum Sound Level (Sound level 0 / Mute):
There will be an Audible double beep.
If Volume Down is pressed again at this level, sound level will not change and double beep will be produced again.
•When Ambient Volume reaches maximum Sound Level (Sound level 14 / +14dB):
There will be an Audible double beep.
If Volume Up is pressed again at this level, sound level will not change and double beep will be produced again.
•Changing Listening Modes:
Press both Ambient Volume Up and Down buttons at the same time.
▪The unit will cycle through the 4 available modes
oUniversal
oClear Voice
oHigh Frequency Boost
oPower Boost
•Charging the device:
Open the Micro USB Connector cover, plug in a Micro USB cable, then plug the other end into a USB power source or adapter.
While the device is charging the LED will remain constant ON. When fully charged the device’s LED will turn blue.
NOTE: When device is turned off, the ear buds will still provide passive NRR.
BLUETOOTH FUNCTIONS
•Pairing the device:
Press the BT Pairing button to enter Bluetooth pairing mode. When the unit is first turned ON it will search automatically for the last
paired device and then connect, if device is not found it will search for a few minutes and if not paired, Bluetooth will automatically enter
pairing mode.
On the device you want to connect to the headphone, follow the manufacturer’s instructions to locate and connect to “Walker’s Razor
XV BT”(Note: Auto re-connects to previous last connected device during pairing if the BT device has been paired previously).
Once paired, the blue LED will be flashing every few seconds. In Pairing Mode, the light will flash Blue then Red until paired.
•Answer Call:
Short press the BT Pairing button to answer incoming call.
•Reject Call:
Long press the BT Pairing button to reject the call.
•Cancel/end call:
Short press the BT Pairing button to cancel/end call.
•Call on hold/waiting:
During phone calling, if another new call is received, double press the BT Pairing button to switch from first call to second call.
To switch back to first call short press the BT button to end the second call and it will be switched to previous call.
•Last number redial:
Double press the BT Pairing button to re-dial the last phone number.
•Audio Pause/play:
Short press the BT Pairing button to pause/play music.
Skip a song by holding the BT volume up/Down
•

NRR Informaon
Although hearing protectors can be recommended for protecon against the harmful effects of impulsive noise, the noise
reducon rang (NRR), is based on the aenuaon of connuous noise and may not be an accurate indicator of the protecon
aainable against impulsive noise such as gunfire.
The level of noise entering a person's ear, when hearing protector is worn as directed, is closely approximated by the difference
between the A-weighted environmental noise level and the NRR.
FCC NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to radio
communicaons. However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be determined by turning the equipment offand on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interference cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15
of FCC Rules.
Specificaons and designs are subject to change without any noce or obligaon on the part of the manufacturer.
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operaon
Please note that changes or modificaons not expressly approved by the party responsible for compliance could void the user’s ability to operate
the equipment

LIMITED WARRANTY
Walker’s warran es this product to the original purchaser to be free from defects in materials and workmanship, under normal use
and condi ons for a period of one year parts from the date of purchase.
Under this warranty, this device will be replaced or repaired at our op on. Copy of the original receipt or gi receipt, is required for
any warranty service. To enact the warranty, the customer is required to contact our Customer Service Group at 877-268-8490 to
receive a Return Authoriza on (RA) number PRIOR to sending the product back.
This warranty is void if any of the following occur:
1. The device is not accompanied by a copy of the receipt or gi receipt from the original purchaser.
2. The device has been tampered with, opened or punctured.
3. The device has been immersed in water or other liquids, allowed to be filled with dirt or dust, or otherwise physically abused.
4. The one year limited warranty has expired. Please inquire about other op ons from your Customer Service Representa ve.
This shall be the exclusive wri en warranty of the original purchaser and neither this warranty nor any other warra nty, expressed or
implied, shall extend beyond the 12-month period listed above. In no event shall Walker’s, Inc. be liable for consequen al property
damage, or consequen al personal injury. (Some states do not allow limita ons on implied warran es or exclusions of consequen al
damages, so that these restric ons may not apply to you). This warranty gives you specific legal rights, and you may have other rights,
which vary from state to state.
Record Serial # for future reference: Serial #
Return bottom portion to Walker’s, Inc. – PO Box 535189 – Grand Prairie, TX 75053-5189
Warranty Registration
Model: Date of Purchase:
Purchased From
City: State: Zip:
Primary Use:
Your Name:
Address:
City: State: Zip:
Email Address: Serial #:
(1) This device may not causeinterference.
1) L'appareil ne doitpas produire de brouillage;
：
Input：5V DC，500mA
Unit Size (mm) 190x160x18mm
Weight 56g