Warrior Products 4860 User manual

Warrior Products, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: [phone]
Fax: [phone]
custom[email protected]
www.warriorproducts.com
QUALITY ●INTEGRITY ●INNOVATION ●SERVICE
2005 –2017 Toyota Tacoma Platform Roof Rack –Double Cab
P/N 4860
Kit Contents:
Item
Qty
Item
Qty
3/8” x 1” Hex Bolt
8
Platform Rack
1
3/8” SAE Flat Washer
16
6mm x 20mm Bolt
8
3/8” Nyloc Nut
8
1/4” Lock Washer (use w/ 6 MM)
8
Mounting Bracket
2
1/4” USS Flat Washer (use w/ 6 MM)
8
Installation Instructions:
1. If you have a factory roof rack, remove it to reveal the factory roof rack mounting points.
2. If you do not have a factory roof rack, remove ditch moldings by using a tape-wrapped flathead screwdriver or
some other soft, flat edge. See Figure 1. This will reveal 10 well nuts (5 driver’s side & 5 passenger’s side).
3. Remove protective tape from the 2 front-most well nuts and 2 rear-most well nuts. Do this on both the driver’s
side and the passenger’s side.
4. Use some RTV silicone sealant around each of
the well nuts, to prevent rusting and water leaks.
5. Locate your mounting brackets. These will have
tabs and a lip facing inwards with a stamped
“WP” towards the rear of the vehicle.
6. Starting with the driver’s side, position the
mounting bracket and loosely attach to the 4
well nuts using the 6mm x 20mm bolts, ¼” Lock
Washers, and ¼” USS Flat Washers.
7. Tighten bolts (torque is approx. 8 ft-lbs). Repeat
step 6 for the passenger side.
8. Place the platform on mounts with the angled
platform tube facing forward. It helps to have a
spare set of hands for this step.
9. Loosely start [4] 3/8” x 1” bolts, [8] washers, and
[4] Nyloc Nuts. The bolts should be placed in
through the center row of slots(Front-to-Rear),
and in the two inner-most slots (Side-to-Side).
See Figure 2. **To clear the factory Sharkfin
Antenna you may have to place the bolts in the
Front row of slots (platform slid back).**
10. Repeat step 10 for opposite side.
11. Visually align platform and tighten all hardware.
12. Installation Complete.
Figure 1
Figure 2
3/8” Bolt Locations
*Front-to-Rear: Centered
*Side-to-Side: Inside Slots

Warrior Products, Inc.
11100 SW Industrial Way
Tualatin, OR 97062
Phone: [phone]
Fax: [phone]
custom[email protected]
www.warriorproducts.com
QUALITY ●INTEGRITY ●INNOVATION ●SERVICE
If you need further assistance installing your product, please contact us by email at
[e-mail] or call us at [phone].