WatchNet PNT Series Instruction Manual

QUICK CONNECTION GUIDE
Package Contents:
Cameras Software CD (X1) Quick Start Guide (X2) Mouse (X1) Remote Control (X1)
PowerAdaptor (X1) Ethernet Cable (X1) Power Cable (X1) Mouse Pad (X1)
KIT dependent
©
WatchNET Products are subject to continuous changes and
improvements, information on this document is subjected to
change without prior notice.
2018 WatchNET Inc. All Rights Reserved
DVR (X1)
Camera power supplies and cable not included.
12V 500mA Power Supply required per camera.
Connecting Your PNT DVR
www.watchnetinc.com
Note:
The connection diagram is using 8CH system, other systems will vary.
PNT Series DVRs use RG59 cables up to 500m.
It is also compatible with most UTP baluns.
Cable distance is dependent on cable quality.
* Not included/sold separately.
Speaker*
Microphone*
720P/1080P HDMI*
Simultaneous Display
720P/1080P HDMI*
Simultaneous Display
Router*
Router*
LAN / WAN
Free DDNS
www.dvrid.com
Smart Phone*
IE/Client for Windows or MAC Client for OSX
USB Mouse
110V AC / 240V AC
12 Volts Power
Power
ON/OFF

EASY START-UP WIZARD
Step
3
Unlock pattern can be used to Login.
Step
1
Language and Video Standard
Step
2
Setup new password - (Please take note of the new password since
tech support can’t resset the password)
Step
4
Email and Security Questions setup.
Please make sure to setup these settings for password recovery.
Step
1
Welcome Screen click Next.
Step
5
Configure the video recording schedule as required.
Click Back to return to previous step or Next to proceed.
Then click Finished.
Step
2
Configure the system’s time and date settings to match the
location’s time zone. Click Next to proceed.
Step
3
Change the default TCP/IP settings to match the local network.
Click the Test button to do a quick test on the configuration.
Click Next to proceed.
Step
4
Enable P2P for remote viewing as required.
The status will say “online” if the network
settings are correct. Click Next to proceed.
The system will go through Device Initialization and Startup Wizard after powering up for the first time. The system will prompt to set the system’s language, video standard, system login information as well as the system’s general settings.
Please take note of the new admin password as it can only be reset by email and security questions. If password cannot be recovered, system has to go thru the RMA process and ship to the manufacturer for factory default.
Device Initialization:
Startup Wizard: