Waterpik Water Flosser CC-01 Series User manual

Mode
Clean
Whiten
Massage
CHARGE
4
•
2
•
ON
OFF
•
8
•
6
•
4
•
2
•
ON
OFF
CC-01 & CC-02 Series
QUICK START GUIDE
Fill
Slide to
Eject
This device is compatible with voltages of 100-240VAC, 50/60Hz ©2019 Water Pik, Inc.
Getting Started (First time use only)
1
Power
ON
Water
ON
High
Fill reservoir with warm
water and replace it firmly
on the base.
Insert tip firmly until
it clicks into place.
Turn pressure to high, point
tip into sink. Push power ON
and slide water switch ON.
Leave on until water flows,
then turn OFF.
ON
OFF
ON
OFF
Insert

Water Floss
2
Turn pressure to low. With water
switch in OFF position, place tip
in mouth. Turn Power ON. Turn
water switch ON.
Close lips enough to prevent
splashing, while still allowing
water to flow from mouth into
the sink. Increase pressure to
your liking.
Aim water at the gumline at a
90° angle. Follow the gumline
and pause briefly between teeth.
TO AVOID MESS: PLACE THE TIP IN YOUR MOUTH BEFORE TURNING WATER ON
CC-01 & CC-02 Series
QUICK START GUIDE
Power
ON
Water
ON
Low
Mode
Clean
Whiten
Massage
CHARGE
4
•
2
•
ON
OFF
ON
OFF
FN 20026587-F AB