Waterpik WP-112 User manual

Insert
Fill reservoir with
warm water and
replace it firmly
on the base.
Set pressure control dial on
base to high,point the
handle and tip into sink.
Turn unit ON until water
flows from tip, turn unit OFF.
Insert tip firmly until
it clicks into place.
QUICK START GUIDE
Review full instruction book prior to first use
1FIRST USE
©2016 Water Pik, Inc.
Model WP-100/112
This device is compatible with a voltage system of 240VAC, 50Hz.

ON
Close lips enough to
prevent splashing, while
still allowing water
to flow from mouth
into the sink.
Aim water at a 90° angle to
your gumline. Follow the
gumline and pause briefly
between teeth.
QUICK START GUIDE
Review full instruction book prior to first use
TO AVOID MESS: PLACE
THE TIP IN YOUR MOUTH
BEFORE TURNING UNIT ON
Turn power on. Start on
low pressure and increase
to your liking.
3
4
2
START WATER FLOSSING
Model WP-100/112
This device is compatible with a voltage system of 240VAC, 50Hz.
20021611-F AA
TECHNIQUE
LEAN OVER SINK
Model WP-100/112
This device is compatible with a voltage system of 240VAC, 50Hz.