weBoost DRIVE 4G-X FLEET User manual

TM
Cellular Signal Booster
460101
Need help? www.WilsonElectronics.com Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
ENGLISH FRANÇAIS
Drive 4G-X™
Quick Install Guide
Package Contents
Quick Install Diagram
Drive 4G-X Signal Booster
Min-Mag Mount Antenna
Slim Low Prole Antenna
DC Power Supply
Outside Antenna Installation
Running Antenna Cable
Inside Antenna Installation
Connect Cables to Drive 4G-X / Power Supply Cord
Connect Power Supply
NEED ASSISTANCE? WE CAN HELP!
Contact our U.S.-BASED CUSTOMER SUPPORT:
n Contact our U.S.-based customer support team at
1-800-501-3153 or email at [email protected]
n Go online for how to resolve the most common issues at
n Find a weBoost Installer on our web site at
Installation is simple, but we’re here to make it even easier.
Alternate Outside Antenna Installations How It Works
For more information refer to full Install Guide at:
https://cellphonesignalphonebooster.us
Product Registration
Thank you for purchasing this weBoost product. Please take time to
register your new product at our website:
Registering is quick and easy, it only takes 2-3 minutes to complete.
Your information is secure, we don’t share or sell your information
to other third parties.
TM
Cellular Signal Booster
460101
Need help? www.WilsonElectronics.com Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
ENGLISH FRANÇAIS
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
RF Safety: Any antenna used with this device must be located at least 8 inches from all persons.
FCC ID: PWO460021 IC: 4726A-460021
Your cell phone is an essential part of your life. weBoost is here to
ensure you have seamless connections on all your cellular devices.
The Drive 4G-X cellular signal booster is a effective solution to all
those times you have lost a call while driving your vehicle due to a
weak cell signal. Installation is simple and can be completed with
minimal tools.
Signal Received and
Transmitted
Power Supply
Outside Antenna
Inside
Antenna
Drive 4G-X
NMO Antenna Assembly
Rubber Seal
Mount to your Boat
or Yacht
Rubber Washer
Mount & Hardware
Drilled Hole
Vehicle Surface
Plastic Washer
NMO Connector
Cable
NMO Antenna RV/Trucker Antenna Marine Antenna
111513_Rev02_01.30.15
THE ALUMINUM CASING OF YOUR SIGNAL BOOSTER WILL ADJUST TO THE TEMPERATURE OF ITS ENVIRONMENT, BUT IS
DESIGNED TO PROTECT THE SIGNAL BOOSTER TECHNOLOGY. FOR EXAMPLE, IN THE SUMMER, THE SIGNAL BOOSTER
CASE MAY BE AS HOT AS 150 DEGREES INSIDE YOUR VEHICLE. THESE HIGH TEMPERATURES WILL NOT DAMAGE THE
SIGNAL BOOSTER, NOR DO THEY POSE A FIRE RISK TO THE VEHICLE. AGAIN, BE SURE TO PLACE YOUR SIGNAL BOOSTER
IN A LOCATION WITH ADEQUATE VENTILATION AND AWAY FROM DIRECT SUNLIGHT OR MOISTURE.
THE DRIVE 3G-X SIGNAL BOOSTER MAY REMAIN ON, IN VEHICLES WHOSE 12V DC POWER SOURCES DO NOT
AUTOMATICALLY SHUTDOWN WHEN THE VEHICLE IS TURNED OFF. THIS COULD RESULT IN DISCHARGING THE VEHICLES
BATTERY IN ONE TO TWO DAYS.
https://cellphonesignalphonebooster.us
https://cellphonesignalphonebooster.us
https://cellphonesignalphonebooster.us

Outside Antenna Installation Running Antenna Cable Inside Antenna Installation
Connect Coax Cables to Drive 4G-X Connect Power Supply to Drive 4G-X Connect to Power Supply
Select a location on top of the vehicle to mount the Mini- Mag
Mount Antenna that is:
Refer to other side for Alternate Outside Antenna Kit Installations.
Run the Outside Antenna cable into the car. The cable is strong
enough that it may be shut in most vehicle doors without damaging
the cable. For a cleaner look, carefully pull down the door seal, run
the cable under the seal, and push the seal back into place. This
method reduces wear on the cable as the door opens and closes.
Identify a place on the side of the seat to mount the Slim Low
Prole Antenna. The location should be at least 18 inches but no
more than 36 inches from where the cellular device will be used.
Peel off the backing of the Velcro® and attach to seat.
Connect the power supply cord to the end of the Drive 4G-X
labeled “Power.” NOTE: Do NOT connect the power to the Signal
Booster until you have connected both the Inside and Outside
Antennas.
1 2 3
4 5 6
DC Power Adapter
switch
Vehicle’s Power Supply
Power Supply
Slim Low Prole Antenna Mini-Mag Mount Antenna
Slim Low Prole Antenna
nNear the center of the vehicle’s
roof.
nAt least 12 inches from any
other antennas.
nFree of obstructions.
nAt least 6 inches from any
windows (including sunroofs).
Select a location for the Drive 4G-X that is free from excessive
heat, direct sunlight and moisture and that has proper ventilation.
Good locations include underneath a seat or under the dashboard.
Connect the cable from the Mini-Mag Mount Antenna to the port
labeled “Outside Antenna” on the Drive 4G-X and connect the
cable from the Slim Low Prole Antenna to the port labeled “Inside
Antenna” on the booster.
Mini-Mag Mount Antenna
Plug the power adapter into vehicle’s 12V DC power supply. Power
up your Drive 4G-X by ipping the switch on the back of the DC
power adapter on. If your Drive 4G-X is working correctly, the lights
will be green.
NOTE: If lights are not green on your weBoost booster, please refer
to the full install guide online or contact customer support at
1-800-501-3153 or email at [email protected]