Weefine Smart Focus 3000 User manual

Please read the manually carefully before using the focus light
Smart Focus 3000
Installing the Battery
Insert the battery into the battery slot,as shown in the
diagram below.
Warning!! The polarity of the battery must match the
polarity of the contacts on the light。Make sure that the
positive and negative poles of the battery aligh with the
positive and negative poles of the light.
GENERAL WARINGS AND INSTRUCTIONS
* Do not disassemble the diving light。
* To avoid leaks the O-rings should be checked to ensure that they are free
from any dirt, sand, hair and dust every time before you open and close
the light。Use a soft cloth to the O-rings if required。The O-rings should also
be carefully checked for cracks or blemishes。Gently and evenly apply a thin
coat of grease to the entire O-rings regularly to prolong O-ring life。Be care not
to scratch the O-ring surface。If cracks or blemishes occur, the O-rings should
be replaced immediately。
* Do not open the light when using in the water。
* Wash the exterior of the light thoroughly with clean fresh water
immediately after use。Soaking the light in fresh water will help
to remove salt deposits prior to storage。
* Do not disassemble, modify,remanfacture,puncture or damage
the device or battery。
BATTERY WARNINGS
*Remove the battery if the light will not be used for long periods
of time (e,g., between dive trips)。
* Do not use a sharp object to remove the battery。
* Keep the battery away from children。
*Contact your local waste disposal department to dispose of the
light/battery in accordance with applicable local laws and
regulations。
*If using an extermal battery charger, only use the WEEFINE
accessory approved for your product。
*Only replace the battery with the correct WEEFINE approved
replacement battery。Using an incorrect battery presents a risk of
fire or explosion。
To purchase a replacement battery, see your WEEFINE dealer or
the WEEFINE website。
Note: under the special working environment, when the light
beads of the high-power LED working in the confined space,
droplets maybe coagulated on the surface of glass. Please don't
worry, this is the normal phenomenon.
Charging the Battery
Step 1: Insert the DC plug into the battery. (As shown in
the diagram below)。
Step 2: Plug the charger into the wall outlet. The
charger's indicator will turn red signifying the charger is
receiving power。
Step 3: When the battery has finished charging, the
charger's indicator will turn green.
Noted: Charge time is approximately 2.5 hours
Attention：
To protect the battery and extend battery life, please do
not charge the battery for more than 12 hours。
20:07:14
Focus / Video light
USER MANUAL

Operating Instructions
Turn on: Press the right and left buttons at the same time
and hold them down for one second. Then immediately press
and release the left button. When the light is turn on it will
be in the white light mode at 100% brightness.
Turn off : Press the right and left buttons at the same time
and hold them down for two seconds.
Switch mode: (White/Red/Blue/Red+Blue)
When the light is on: Press and immediately release the left
button.( White-Red-Blue-Red+Blue-White)
Adjust brightness:(White)
When the white light is on: Press and immediately release the
right button.( 100%-75%-50%-25%-100%)
Adjust brightness:(Red)
When the red light is on: Press and immediately release the
right button.( 100%-50%-25%-100%)
Adjust brightness:(Blue)
When the blue light is on: Press and immediately release the
right button.( 100%-50%-25%-100%)
Adjust brightness:(Red+Blue)
When the Red+Blue light is on: Press and immediately release
the right button.( 100%-50%-25%-100%)
Flashing signal mode:(White)
Turn on: When the light is off, press the right and left buttons
at the same time and hold them down for two seconds.
Turn off: When the light is off, press the right and left
Strobe mode: (White/Red/Blue)
When the light is on, Press the right button and hold it down
for 1.5 seconds the Strobe mode will be on and the focus
light will be the previous color with a low power. When the
strobe mode is on, press the right button and hold it down
for 1.5 seconds the Strobe mode will be off and the light will
be back to the previous mode.
Switch mode: (White/Red/Blue) (Strobe mode)
When the light is on: Press and immediately release the left
button.( White-Red-Blue-White)
Adjust brightness:(White) (Strobe mode)
When the white light is on: Press and immediately release the
right button.( 100%-50%-25%-0%-100%)
Adjust brightness:(Red) (Strobe mode)
When the red light is on: Press and immediately release the
right button.( 100%-50%-0%-100%)
Adjust brightness:(Blue) (Strobe mode)
When the blue light is on: Press and immediately release the
right button.( 100%-0%-100%)
3000 lumens White /10W Red /18W blue
100°
Approx. 50 minutes (100% White)
White / Red / blue
100% / 75% / 50% / 25%
100% / 50% / 25%
100% / 50% / 25%
3*18650 wrapped to single cell
5000K （White)
100m / 330ft
505g on land 255g underwater
56(D) x 137(L)mm
Features
Standard Accessories
□ Focus Light □ Battery □ Charger □ Spare O-rings
□ User Manual □ O-ring Remover
① Right Button ② Left Button
③Battery Level Indicator LED
④ Light Head ⑤Tail ⑥ Flood Beam LED
⑦Red Beam LEDs ⑧Blu-ray LED ⑨ Strobe port
⑩Remote port
The remote control is an optional accessory
Automatic Protection Against Overheating
When the light is used in areas in which the ambient
temperature is higher than 50 °C, the light will
automatically reduce the brightness to 20%, this will
reduce heat and protect the light components from
damage.
Safety Mode
When the battery is almost excharged, the light output drops
automatically to 20% the light turns off after enters Safety
Mode in approximately 10 minutes. Unable to switch the mode
and adjust the brightness.
Battery Level Indicator
There are four colors to indicate the amount of power
remaining in the battery and the function modes.
Blue approx. 100%~80%
green approx. 80~30%
Red approx. 30~10%
Single Blinking Red approx. 10~0%
Triple Dual Blinking The Current mode is Strobe Mode
Brightness：
Beam Angle：
Burn Time：
Modes:
White Power Level:
Red Power Level:
blue Power Level:
Battery：
Color Temperature：
Depth Rated：
Weight：
Dimension：
Specifications
⑤
⑦
⑧
⑥
④
⑨
⑩