Welbilt Manitowoc K00497 User manual

Instruction Sheet K00497 Touchless Lever Activated Ice Chute
CONVERT PUSH FOR ICE TO TOUCHLESS
1 of 2
 DocumentNumber:000016424 7/20
MANITOWOC ICE
2110 SOUTH 26TH STREET, MANITOWOC, WI 54220
844-724-CARE
WWW.MANITOWOCICE.COM
Engineered for ease
1. Disconnect the power from the dispenser by unplugging
the power cord from the electrical outlet.
2. Using a phillips head screwdriver, remove the two screws
located on both sides of the ice chute.
3. With the screws out remove the front panel by grasping
both sides and pulling towards you until it is clear of the
ice chute, then pull the panel up and out.
4. Remove the metal outer bracket clip, then use your
thumbs to spread the bracket and unhinge the ice chute
from the bracket pins.
5. Lift the door lock and rotate the ice chute clockwise
while pulling towards you in a slightly downward motion
to complete removal.
6. Put the new ice chute into place by lifting the door lock
and door lock assembly. Rotate the chute counter
clockwise in an up and away from you motion, but do
not snap the bracket pins into place. Rest the chute on
top of the pins. This is so you can angle the longer chute
through the chute opening as you put the front panel
back on the dispenser.
7. Place the bottom edge of the front panel on the lower
brackets of the dispenser so that the front panel can be
put back into position with a “scissor” like motion while
simultaneously angling the ice chute through the front
panel opening.

2 of 2
DocumentNumber:000016424 7/20
K00497 Touchless Ice Chute Conversion From Push For Ice
8. Return the front panel to its “in place” position and slide
the chute through the opening, but do not push the
front panel all the way back as shown below.
9. Working from the front opening you can now align the
ice chute with the bracket pins and snap into place.
10. With the Touchless ice chute now snapped into the
bracket pins, replace the bracket clip across the front of
the chute bracket by reaching through the front panel
opening and snap into place.
11. With the bracket clip in place the Touchless ice chute is
now secured. The front panel can now be pushed all the
way into place.
12. Once the front panel is pushed all the way back into it’s
final position, replace the two screws on both sides of
the Touchless ice chute.
13. Plug unit back in for operation.
14. Test the operation of the dispenser by pushing ice chute
to dispense ice.