West Elm morgan User manual

morgan lateral le cabinet
assembly instructions
Page  of 0797874—06/06
! Tools required:
! Do not throw away packaging materials until assembly is complete.
! Assemble this item on a soft surface, such as cardboard or carpet, to protect nish.

morgan lateral le cabinet
assembly instructions
Page  of 0797874—06/06
A
Leveler (pre-installed) X 4
B
1
Large wooden dowel X 28
C
Drawer left upper side panel x 1
2
D
3
Drawer right side panel x 2
E
4
Cam lock X 30
Drawer bottom panel x 2
F
5
Cam lock bolt X 30
Drawer front panel x 2
G
6
Back panel x 1
H
7
Left side panel w/ drawer clip x 1
8
Drawer screw X 4
Drawer pull with screw X 4
Drawer back panel x 2
Drawer left lower side panel x 1
Bolt with Flat & Lock
Allen key X 1
washer x 12

morgan lateral le cabinet
assembly instructions
Page  of 0797874—06/06
I
Right side panel x 1
J
9
Bottom panel x 1
Back board screw X 21
K
Front rail x 1
10
Aluminum file hanging rod X 8
11
mounting bracket X 4
Back rail x1
L
M
Top panel x1
N
Middle rail x 1
O
Long screw X 2
Leg x 2 sets
Short screw X 2
Drawer bottom stiffener X2
15
12
13
14
16
Nylon strap X 2
M
e
t
a
l w
a
ll
a
n
c
h
o
r X
2

morgan lateral le cabinet
assembly instructions
Page 4 of 0797874—06/06
. Screw cam lock bolts (E) into drawer side panels (,,4).
. Insert cam locks (D) into holes in drawer back panel (). Be sure the arrow on the cam lock points toward the cam bolt as shown.
. Insert cam lock bolts into cam locks and tighten with a phillips screwdriver.
NOTE: The arrow of the cam lock should
be pointing to the cam bolt when placed
in hole as shown.
2,3
E
D
1
4

morgan lateral le cabinet
assembly instructions
Page  of 0797874—06/06
E
2,3
4
5
6
4. Screw cam lock bolts (E) into drawer front panels (6).
. Slide drawer bottom panel () into drawer sides as shown.
6. Insert cam locks (D) into holes in drawer side panels. Be sure the arrow on the cam lock points toward the cam bolts. Insert cam
lock bolts into cam locks and tighten with a phillips screwdriver.
D
6

morgan lateral le cabinet
assembly instructions
Page 6 of 0797874—06/06
16
G
7. Slide drawer bottom stiffeners (6) into drawer bottoms and fasten with drawer screws (G). Tighten screws with a phillips screw-
driver.
H
8. Fasten drawer pulls (H) to drawer fronts as shown. Tighten screws with a phillips screwdriver.
Upper Drawer Lower Drawer
Drawer
Clip
JJ
9. Insert aluminum le hanger rods (J) into notches in drawers.

morgan lateral le cabinet
assembly instructions
Page 7 of 0797874—06/06
0. Fasten legs to the base using bolts, lock washers, at washers (C) and wooden dowels (B) in order as shown. Tighten bolts
using the allen key (F). Be sure to orient legs in the correct position as shown.
. Screw cam lock bolts (E) and insert dowels (B) into front rail () and back rail () as shown in details below.
. Insert cam locks (D) into holes in middle rail (4). Be sure the arrow on the cam lock points toward the cam bolt. Insert cam
lock bolts into cam locks and tighten with a phillips screwdriver.
. Screw cam lock bolts (E) and insert dowels (B) into left side panel (8), and right side panel (9).
4. Insert cam locks (D) into holes in front rail () and back rail (). Insert cam lock bolts into cam locks and tighten with a phil-
lips screwdriver.
C
FF
8
9
B
11
12
14
E
camlock
D

morgan lateral le cabinet
assembly instructions
Page 8 of 0797874—06/06
8
9
B
. Insert dowels (B) into top edge of sides (8,9) as shown.
6. Fasten top to sides using bolts, lock washers, and at washers (C) in order as shown. Tighten bolts using the allen key.
C

morgan lateral le cabinet
assembly instructions
Page 9 of 0797874—06/06
7. Insert dowels (B) into bottom edge of sides.
8. Fasten base to sides using bolts, lock washers, and at washers (C) in order as shown. Tighten bolts using the allen key (F).
9. Fasten back panel (7) into back of cabinet using back board screws (I). Tighten screws with a phillips screwdriver.
7
I
B
F
C

morgan lateral le cabinet
assembly instructions
Page 0 of 0797874—06/06
Upper Drawer
Lower Drawer
Drawer Clip
0. Insert drawers into cabinet as shown.
. Adjust levelers as shown to prevent tipping.
CARE INSTRUCTION
Hardware may loosen over time. Periodically check that all connections are tight.
Wipe with a soft, dry cloth. To protect nish, avoid the use of chemicals and household cleaners.

morgan lateral le cabinet
assembly instructions
Page  of 0797874—06/06
CARE INSTRUCTIONS
Hardware may loosen over time. Periodically check that all connections are tight.
Wipe with a soft, dry cloth. To protect nish, avoid the use of chemicals and household cleaners.
back side.
wall.
OVER BALANCE. To prevent injury and property damage from unexpected tipping of furniture, we highly recommend
installation of the two (2) sets of overbalance protection hardware included with this product.
1. Attach the two mounting brackets securely to the back edge of the furniture. Place one on
each of the side panels.
2. Determine where the furniture is to be placed and mark location on the wall for the other two
mounting bracket screw holes. It should be placed approximately 2” below the bracket mounted
to the furniture.
3. Drill a 3/16” hole in the wall. Press the plastic anchor into the hole and gently tap until the
flange on the anchor is against the wall surface.
4. Position the bracket over the anchor and use a screw to securely attach the bracket to the wall.
Repeat steps 3 and 4 for the second bracket .
5. Place the furniture so the brackets on the back edge is in line with the brackets on the wall.
6. Lace an end of the nylon restraint strap down through each bracket. Bring both ends together
and slide the beaded end of the strap through the keyhole shaped slot in the other end until
snug. Pull down on the beaded end until it snap locks into the keyhole slot.
7. To double lock, return the beaded end back through the keyhole.
8. Check to make sure the strap is securely laced and locked to the brackets.
9. Repeat steps 6 through 8 for the second bracket set.