Wholesale Interiors BBT 6737 User manual

PAGE 1 OF 3
PART LIST
ITEM DESCRIPTION QTY
AHEADBOARD 1 PC
BFOOTBOARD 1 PC
CSIDE RAIL 2 PCS
DCENTER RAIL 1 PC
ECENTER SUPPORT 2 PCS
FCENTER SUPPORT LEG 3 PCS
HARDWARE LIST
ITEM DESCRIPTION QTY
1JCBC BOLT M6 x 20mm 8 PCS
2M6 FLAT WASHER 8 PCS
3M6 SPRING WASHER 8 PCS
4WOOD SCREW M3.5 x 16mm 8 PCS
5WOOD SCREW M4 x 20mm 2 PCS
6BED SLAT SIDE FITTER 24 PCS
7BED SLAT CENTER FITTER 12 PCS
8M4 ALLEN KEY (BALL SHAPE) 1 PC
9M5 ALLEN KEY (BALL SHAPE) 1 PC
GBED LEG 4 PCS
HBED SLAT 24 PCS
Read this instruction carefully. See hardware and furniture part list for guidance.
Be sure all parts are complete, before you assemble. Place all wooden furniture
parts on a clean and flat soft surface to prevent from being scratched.
Follow the figure to start assembling.
CAUTIONS :1. Do not FULLY - TIGHTEN the nut or nut bolt until all nut or bolt is ready assembed.
2. Do not OVER - TIGHTEN the nut or bolt to avoid causing damages to the thread.
3. Keep all hardware parts out of reach of children.
NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY.
Tool needed : Screwdriver (not provider).
ASSEMBLY INSTRUCTIONS
MODEL : BBT 6737 FULL Bed
STEP 1
STEP 2
D
F
A
B
9
X 4
Loosen the pre-inserted bolt on the
headboard and footboard using
Allen key ball shape (9).

ASSEMBLY INSTRUCTIONS
Note: Assemble (E) vertically
as picture shown.
STEP 3 X 4 STEP 4
X 4
STEP 5
STEP 5.1 STEP 5.2
C A
18 32
GA
C
9
A
D
E
C
PAGE 2 OF 3
4
NOTE :
Make sure the floor is
clean and smooth
when put down the bed
to prevent scratches.
X 2 X 4

ASSEMBLY INSTRUCTIONS
* When moving the bed position, the center support legs
must be adjust to be straight to avoid any broken problem.
Palm
STEP 6 X 2 STEP 7 STEP 7.1
STEP 7.2
Palm
5
7
H
H
H
H7
6
6
PAGE 3 OF 3
D
STEP 8
6
H