Williams Sound Digi-Wave DLT-100 User manual

0845 5576555
www.tourguide-systems.co.uk Out of hours try:
07973 395180 or 07973 759174
Page 1
Overview:
One guide addressing the tour party (group) who are either listening directly to the
tourguide (floor language) or to the interpreter(s) language.
TOURGUIDE USE DLT100
The main speaker
Plug-in the headworn microphone
Touch and hold for power on/off.
The TALK button is illuminated and the
microphone will be live (leave this ON).
Channel = 00, the floor language
INTERPRETER(S) USE DLT100
Plug-in the headset/boom microphone
Touch and hold for power on/off.
The TALK button is illuminated and the
microphone will be live (leave this ON).
Channel = 01, first interpreter’s language
Grp1
START
HERE
——>
Grp1
Your hire system will normally be sent out ready to use, configured to the default settings for
Simultaneous Interpretation Mode (SI) and will be on Group 17.
Turn to next page for setup of the DLR50 receivers (listen only).
The table below shows the setup procedure, should this be needed.
DigiWave hire system
QUICK GUIDE—Tourguide + Interpreter(s)

0845 5576555
www.tourguide-systems.co.uk Out of hours try:
07973 395180 or 07973 759174
Page 2
DigiWave hire system
QUICK GUIDE—TOURGUIDE + INTERPRETER MODE
Once you have switched ON the DLT100 for the tourguide and interpreter(s) you can
proceed to switch ON the DLR50 receivers for the tour party.
GENERAL NOTES
REHEARSE & TEST: obvious maybe, but allow time to familiarise yourself with the system operation
and walk a rehearsal tour with colleagues, so you know what your visitors will experience.
RANGE: up to 100ft (30m) indoors and up to 200ft (60m) outdoors (line-of-sight, depending on
conditions).
MULTIPLE TOURS: ensure returning groups keep the receivers with their corresponding tourguide—
dedicate a table-top for each group so the guides know where to return the receivers.
TOUR PARTY
LISTEN USING DLR50
WITH A PLUG-IN
EARPIECE,
HEADPHONES,
EARDEFENDER
HEADPHONES
or NECK LOOP (for
hearing aid users).
USES 2xAAA ALKALINE BATTERIES (DISPOSABLE)
AND LASTS 24HRS.
To turn on the DLR50 receiver, push and hold
the Power ON/OFF button.
The receiver will automatically select the
first interpreter language, channel 01.
If the display flashes “88” ...
hold down the Channel UP/DOWN
buttons together for 3 seconds until the
display flashes “Gr”. Press UP or DOWN
to select “17”, then hold down the UP/
DOWN buttons for 3 secs to save.
To select the next language (if available) press
the CHANNEL UP/DOWN button briefly,
the unit will scroll to the next available
channel; repeat until the desired channel
is selected.
The main speaker (floor language) is
always channel 00.