WINBO H126202 User manual

INSTALLATION INSTRUCTION
RUNNINH BOARD FOR MITSUBISHI PAJERO
PART No. H126202
Page 1 of 2 NO. SMEN-H126202-WINBO(1)A1
ATTENTION
Read the instructions completely before you begin the installation. NOTE: Pictures are for reference
only, actual part may be different. Installation is the same.
You may need to periodically to re-tighten all hardware, such as one month or two month.
PART LIST
No.
Name
Qty
Remarks
No.
Name
Qty
Remarks
○
1
Running board
2
○
6
Hex nut
8
M10
○
2
F-Mounting Brackets
2
○
7
Flat washer
20
10mm
○
3
M-Mounting Brackets
2
○
8
Spring washer
12
10mm
○
4
R-Mounting Brackets
2
○
9
Hex bolt
4
M10×1.25×25
○
5
Hex bolt
8
M10×25
○
1
Chassis
FIG#1
○
2
FRONT
Hardware from the running board
○
3
○
5○ 6○ 7○ 8
Chassis
○
5○ 6○ 7○ 8
○
7○ 8○ 9
○
4
Chassis

INSTALLATION INSTRUCTION
RUNNINH BOARD FOR MITSUBISHI PAJERO
PART No. H126202
Page 2 of 2 NO. SMEN-H126202-WINBO(1)A1
INSTALLATION STEPS
Step 1：Check all the contents are available in accordance with the above list.
Step 2：Remove the factory running board and mounting brackets.
Step 3：Install the F-mounting brackets and M-mounting brackets to the vehicle using hardware as
shown in FIG#2.
Step 4：Install the R-mounting brackets to the vehicle using hardware as shown in FIG#3.
Step 5：Install the running board to the mounting brackets using hardware as shown in FIG#1.
Step 6：Test and make sure that the running board is steadily fixed.
Step 7：Installation is finished.
FIG#2
FIG#3
○
7○ 8○ 9
○
5○ 6○ 7○ 8