Wireworks Eclipse Installation manual

W
A Fit backboard to wall using supplied wall screws
and wall plugs if suitable. Check backboard will
support upto 8kg before fixing other components.
Consider where you want the magnifier mirror
positioned before fixing backboard.
B Position the large flat round mirror over
the backboard so that the mirror screws
can be fixed from the side edge to the
backboard and mirror. Tighten screws with
a screwdriver.
x 2 wall screws
x 2 wall plugs
x 6 mirror screws
x 1 ball joint
Fixings included:
backboard
wireworks
.
london
Eclipse Wall Mirror - Installation and Care
Thank you for purchasing this wall mirror. Please read instructions carefully before use to ensure
safe and satisfactory operation of this product. It is recommended that this mirror is fitted only by
persons competent in DIY.
The Mirror is supplied with screws and wall plugs suitable for a stone or brick wall. For all other wall types
(eg. hollow plasterboard) alternative fixings will be required. If in doubt consult a qualified person.
You will need a power drill, masonary drill bit, cross-head screw driver and adjustable spanner to install this
product. Ensure the wall surface is of suitable strength and construction before fixing the mirror.
magnifier mirror
position
W
large flat round
mirror

W
C Fit the locking strip using four mirror screws.
Tighten using a screwdriver.
Check the mirror is securely fastened.
D Using a spanner fit the the ball joint tightly into the
backboard. End B goes into the backboard.
Fit the magnifying mirror onto the ball joint, secure
tightly using a spanner. End A goes into the
magnifying mirror.
Check the magnify mirror and ball joint do not come
loose when the magnify mirror is turned. Tighten if
necessary.
AB
locking strip
ball joint
wireworks
.
london
Before use check the mirror is secure
and the magnify mirror does not loosen
when rotated.
Clean wood using a soft damp cloth.
Use glass cleaners for the mirror.
Fit in accordance with manufacturers
instructions. Retain for future use.
Complies with: BS7449:1991
Mirror thickness 3mm lm backed
Model ref: BA.ECLIPSE
A
B
back board
magnify mirror
spanner
spanner