Wireworks Round Caddy 4 Tray User manual

Fixings (as marked):
A Female screw x16
B Twin hole pad x8
C Male screw x16
Parts (as marked):
1 Base tray with non slip feet - x1
2 Handle - x1
3 Tray - x3
Thank you for buying ‘Round Caddy 4 Tray'
Assembly instructions.
1
2
3
C
B
A
B
.wireworks
london
CARE INSTRUCTIONS:
. Wipe clean using a soft damp cloth.
. Do not use abrasive cleaners
which may contain ammonia or
solvents and could damage the
surface finish.
. Do not expose to excessive
heat or humidity.
. Do not leave in prolonged
contact with water.
CAUTION:
. Adult assembly required.
. This item contains small parts that
have sharp points and edges in the
unassembled state.
. Take care not to scratch surface
finishes when unpacking and during
assembly.
. Maximum load per tray 1.5kg.
3
3

1
2
3
Adjust all the trays at right angles to the handle and tighten the screws.
2
1
B
.wireworks
london
Stick the twin hole pad B to the inside face of the handle 2 so the holes are aligned.
Loosely fix the tray with silicon feet 1 to bottom of the handle 2 Before continuing
double check you have picked the correct tray for the base.
Fix the middle and upper tray to the handle using supplied screws A & C and
pads B in the same way.