WolfPack HE23U User manual

1
ITEM NO.: HE23U 4K2K 60Hz HDMI (HDBaseT) CAT5e Extender
with USB/IR/RS232
HE23U HDMI CAT5 Extender is using only one cost effective CAT.5e/6 cable to extend your
UHD display up to 100 meters at 4K2K 60Hz. With USB, Bi-directional RS232 and IR function
to delivers significant value to the entire home and commercial entertainment system.
HE23U 4K2K 60Hz HDMI (HDBaseT) CAT5e Extender with USB/ IR/RS232
Features:
Extends HDMI, USB,RS232 and IR signal over one CAT5e/6 cable.
HDBaseT 2.0, HDCP 2.2 & DVI Compliant.
Uncompressed high definition video up to 4K2K@60hz (YCbCr 4:2:0).
Audio supports up to LPCM 7.1 @ 192KHz, Dolby TrueHD, DTS-HD MA
Transmission range up to 100 meters at 4K2K resolution.
Bi-directional IR, support 30-60khz.
Bi-Directional RS232.
USB support USB 2.0 and USB 1.0 and 1.1.
Perfect for 4K2K touch panel application.
Installation view:
Cable:
Link cable recommend use high quality CAT.5e、CAT.6、CAT.6a、CAT.7 UTP / STP or FTP cable.
Poor quality cable or network connection or improper construction will cause unstable
connection, video or sound disruptions, picture noise appears.
HDMI (HDBaseT) CAT5 Extender Series

2
HDBaseT Distance chart by different cable:
If connection through the wall socket, the cable length must less 100 meters between HDMI
extender and wall jack, as below drawing:
Panel view:
HE23UT
HE23UR
LED Instruction:
Switch Function:
1. RS232 ON : Firmware Update ,OFF : RS232 Extension
2. LINK MODE ON : Low Power ,OFF : Long Reach
3. IR MODE ON : Polarity Reverse ,OFF : Default
4. IR RX TYPE ON : Pinout Exchange ,OFF : Default
Remark: IR mode and IR RX type is for 3rd Party IR system which use different
polarity and pinout, please check with your IR system supplier.
Cable Type
Range
Pixel Clock Rate
Video Data Rate
Supported Video
CAT5e
100M
<=225Mhz
<=5.3Gbps
(HD Video)
Up to 1080p, 60 Hz, 36 bpp
(data rates lower than 5.3
Gbps or below 225 MHz
TMDS clock).
90M
>225Mhz
>5.3Gbps
(Ultra HD Video)
1080p 60 Hz 48 bpp, 1080p
60 Hz 3D, 4K2K/30Hz/4:4:4
and 4K2K/60Hz/4:2:0 video
formats
CAT5e/CAT6a/C
AT7
100M
Color
Status
HE23UT
HE23UR
GREEN
ON
ON: Power on
BLUE
LINK
ON: HDBaseT Linking
RED
HDCP
OFF: HDMI unlink, ON: HDCP enable , Flash: HDCP disable
Color
Status
HE23UT
HE23UR
GREEN
STATUS
ON: IR Polarity Reverse (third party IR system)
BLUE
IR RX
ON: Receiving IR signal
RED
IR TX
ON: Sending IR signal
Transmitter
Wall Jack
Wall Jack
Receiver
MAX 100M
< 5M
< 5M
ON
1 2 3 4

3
RS232 Define:
DB9(F)/3.5mm STEREO PHONE JACK DB9(M)/3.5mm STEREO PHONE JACK
RS232
3.5 mm Phone Jack
RS232
3.5 mm Phone Jack
Footprint
Define
Footprint
Define
Footprint
Define
Footprint
Define
Pin 2
TX
Pin 1
RX
Pin 2
RX
Pin 1
RX
Pin 3
RX
Pin 2
TX
Pin 3
TX
Pin 2
TX
Pin 5
GND
Pin 3
GND
Pin 5
GND
Pin 3
GND
RJ45 Define:
Video Link (TIA/EIA-568-B)
1. Orange-white DATA0 +
2. Orange DATA0 -
3. Green-white DATA1 +
4. Blue DATA2 +
5. Blue-white DATA2 -
6. Green DATA1 -
7. Brown-white DATA3 +
8. Brown DATA3 -
Caution:
1. The wiring must away from any equipment with electromagnetic wave, i.e.: mobile phone,
microwave, radio equipment, fluorescent lamp, high voltage power lines.
2. The cable must pull in straight to avoid any crosstalk interference and the transmission
stability.
3. This device HDBaseT port is not general Ethernet signal; do not connect with Network
devices to avoid damage.
4. IR transmitter do not put near from receiver to avoid mutual interference.
Package Include:
HE23UT HDM Transmitter x 1 pcs
HE23UR HDMI Receiver x 1 pcs
IR Blaster Cable x 1 pcs
IR Receiver Cable x 1 pcs
USB A/B cable x 1 pcs
DB9 (M)/3.5mm STEREO PHONE JACK x 1
DB9 (F)/3.5mm STEREO PHONE JACK x 1
Mounting Screw pack x 2 bags
DC5V 2Amp Power Adapter x 2 pcs
DB9(F)/3.5mm STEREO PHONE JACK
DB9(M)/3.5mm STEREO PHONE JACK

4
Specification:
Rev. A
ITEM NO.
HE23UT
HE23UR
HDMI Connector
HDMI Type A x 1
HDMI Video Support
1080p @ 60Hz @ 48bits、3D、4K x 2K(YCbCr 4:2:0)
HDMI Audio Support
Up to 7.1 LPCM 192KHz / Dolby TrueHD / DTS-HD MA
HDBaseT Connector
RJ45 x 1
HDBaseT Distance
100M
RS-232 Interface
DB9(F)/3.5mm STEREO PHONE JACK
DB9(M)/3.5mm STEREO PHONE JACK
RS-232 Baud Rate
115200 bps / full duplex
IR Input/Output
3.5mm Phone Jack x 2
IR Carrier
Frequency/Angle/Distance
20~60KHz / T：± 10° / R：± 55° / 5M /Bi-directional
USB input/output
USB Type B x 1
USB Type A x 1
Power Consumption
800mA
1200mA
Power Adapter
DC 5V 2A
Temperature
Operation: -10 to 45℃, Storage: -30 TO 75℃, Humidity: up to 95%
Dimensions mm
109.6 x 109.5 x 30
Weight g
280