WoMaster DS105 User manual

DIN Rail mount
Attach the DIN Rail Clip to the two wall mount plates. The DIN Rail
should comply with DIN EN50022 standard. Using wrong DIN rail may
cause unsafe installation.
Quick Installation Guide
Industrial 5-port Unmanaged
Ethernet Switch
DS105
DS105 is a cost effective industrial 5-port Ethernet switch for industrial
Ethernet connection. The rugged design can stand for harsh
environment and wide temperature (from -40 to 75°C) use. Ultra low
power design consumes less than 1W during full traffic. The compact
size can fit in for space limited installation such as vehicle wall-
mounting or Din-mount for cabinets. Micro USB DC 5V power input is
flexible for installation.
・Overview
✓1 x Product Unit
✓1 x 3-pin Removable Terminal Connector
✓1 x DIN Bracket set
✓1 x Quick Installation Guide
Optional Accessory (for detailed information please refer to the
Datasheet)
・Package Checklist
www.womaster.eu
Wall mount
Two wall mounting plates are installed at the left and right side of the
switch. Use the two hook holes at the corners of each wall mounting
plate or the middle hole to hang the switch on the wall them then
screw tightly.
・Installation
LED Status Description
PWR Green On DC-IN Power is On
Off No Power in DC-IN
Ethernet Port
(Port 1~5)
Green On Links established
Green Blinking Packets transmitting/receiving
Off Link is inactive
Wall Mount Clip
USB POWER INPUT
5 VDC
DC 5 ~ 30V
V+ V- G
** Caution: Do not connect the power supply before and after
wiring to avoid damage or electric shock.
** Note: It is supported with Redundant power design:
5~30V/USB 5V
Power Input (Terminal Block or Micro USB)
Terminal Block
1) Insert the positive and negative wires into the V+, V- and G contact
on the terminal block connector.
2) Tighten the wire-clamp screws.
3) Connect the power wires to suitable DC Switching type power
supply.
Bottom Panel
3
4
5
Top Panel
1
2Power
Connector
Micro USB
Power Input
LNK
ACT
PWR
1
2
4
35
・LED Indicator
➢Turn off DC power input source before connecting the DC Power
supply module to the terminal block connectors. Do not turn-on the
source of DC power module and make sure all connections were well
established, then power on the DC source to powering the Switch
device.
➢Never install or work on/with the equipment or the cabling during the
period of lightning activity.
・Safety Precautions
・Appearance
DS105
Wall Mount Clip
System LED
・1 x Power
・5x Ethernet Port
USB 5V Power Input
・Micro USB connector
Ethernet Network
・5-port 10/100MBase-TX
(3-port on top, 2-port on bottom)
Wall Mount Clip
Integrated Power
Connector
・3-Pin Removable
Terminal Connector

www.womaster.eu
・Support
At WoMaster, you can use the online service forms to request the
support. The submitted forms are stored in server for WoMaster team
member to assign tasks and monitor the status of your service. Please
feel free to write to [e-mail] if you encounter any problems.
WoMaster reserves the right to make changes to this QIG or to the
product hardware at any time without notice. It is the user’s responsibility
to determine whether there have been any such updates or amendments
herein.
Defects, malfunctions, or failures of the warranted Product(s) caused by
damage resulting from unforeseeable incidents (such as lightings, floods,
fire, etc.), environmental and atmospheric disturbances, other external
forces such as power line disturbances and surge, host computer
malfunction and virus, incorrect power input, or incorrect cabling, incorrect
grounding and damages caused by misuse, abuse and unauthorized
alteration or repair are not warranted.
・Disclaimer
・Warranty
5-year Global warranties are available for WoMaster products assuring
our customers that the products shall remain free from defects in
workmanship or materials and conform in all material respects to
WoMaster specifications, or Purchaser’s supplied and accepted
specifications. The warranty is limited to the repair and/or replacement, at
WoMaster' sole discretion, of the defective product during its warranty
period. The customer must obtain a Return Merchandise Authorization
(RMA) approval code prior to returning the defective Product to WoMaster
for service. The customer agrees to prepay shipping charges, to use the
original shipping container or equivalent, and to insure the Product or
assume the risk of loss or damage in transit. Repaired or replaced
products are warranted for ninety (90) days from the date of repair or
replacement, or for the remainder of the original product's warranty period,
whichever is longer.
V1.1 June 20, 2019 3160-0DS1050-01 © WoMaster Inc. All rights reserved.