Woodstock Shop fox D4648 User manual

Specifications
Model
Jaw
Width
Workbench
Thickness
Max. Jaw
Opening Weight
D4648 13" 11⁄2" 5
7⁄8"13 lbs.
Introduction
Your new Front Vise (see Figure 1) is designed to fit on
workbenches 11⁄2" thick. The front vise features a solid
hardwood clamping jaw pad.
1. With help from an assistant, hold front vise up
against workbench in desired mounting location.
Note: If your workbench has holes for bench dogs,
ensure bench dog holes on top of vise jaw (see
Figure 1 and Figure 4 on Page 2)align with those
holes.
2. Use a pencil to mark underside of workbench
through six vise mounting holes (see Figure 2) to
drill pilot holes in workbench.
3. Use a 1⁄8" drill bit to drill pilot holes approximately
1" deep in underside of workbench (see Figure 3).
4. Attach vise assembly to workbench using (4) #10 x
1" wood screws through underside of workbench, as
shown in Figure 3.
Installation
The Cabinet Maker's Front Vise comes fully assembled
from the factory. Mounting hardware is not provided with
this front vise.
Figure 1. Model D4648 front vise.
Bench Dog Holes
Figure 2. Mounting hole locations (viewed
from below).
Mounting Holes
Vise
Wood
Screws
Workbench
Figure 3. Mounting diagram.
COPYRIGHT © AUGUST, 2017 BY WOODSTOCK INTERNATIONAL, INC., REVISED JULY, 2022 (CS)
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. (MFD 07.19+) Printed in China#19127JH V2.07.22
Phone #: [phone] • Tech Support: [e-mail] • Web: www.woodstockint.com
Model D4648
Cabinet Maker's Front Vise
Instruction Sheet
***Keep for Future Reference***

-2-
D4648 Front Vise Instructions
Rotating the vise handle (see Figure 4) clockwise moves
the movable jaw toward the fixed jaw.
Rotating the vise handle counterclockwise moves the
movable jaw away from the fixed jaw.
Handle
Figure 4. Vise operation.
The painted parts of the vise can be cleaned with a damp
rag. If wood pitch has built up on the components, clean
this with a pitch-dissolver or blade and bit cleaner.
Lubricate the leadscrew with a dry lubrication, such as
silicone or graphite, that will not cause sawdust to stick
to the threads.
If material becomes built up on the threads, clean
thoroughly with a pitch-dissolver.
Maintenance
Operation
1V2
2V2
3
4V2
REF PART # DESCRIPTION REF PART # DESCRIPTION
1V2 XD4648001V2 VISE HANDLE ASSEMBLY V2.07.19 3XD4648003 WOODEN VISE FACE, BIRCH
2V2 XD4648002V2 VISE SET ASSEMBLY V2.07.19 4V2 XD4648004V2 WOOD SCREW #8 X 1 V2.07.19
D4648 Parts
Bench Dog Holes