Wunderkind Custom Fender Original instructions

• www.wunderkind-custom.com ••• [e-mail] •
Installation manual and safety information
Fender
Indian Springfield
From model year 2021

Installation manual for Fender
• Revision: 00 • 27/10/2021 • © ABM Fahrzeugtechnik GmbH Page 2 of 4
Caution
Important safety advice:
Working on motorcycles poses a safety risk. Some work may only be carried out by appropriately
qualified personnel. Faulty work can have serious consequences and may pose a threat to life and
health. Only undertake installation works if you are sufficiently qualified and have an official workshop
manual as well as all relevant service notifications available. Otherwise, we strongly recommend that
the installation is carried out or at least checked in a specialist workshop.
Any work in relation to the installation, removal and tightening torque of original parts should always be
carried out in compliance with the workshop manual.
All screws must be attached with thread-locking fluid. However, this should only be done after the
installation is complete.
It is your responsibility to check the product regularly and to determine if a service or replacement is
required.
Please bear in mind that some products are safety-relevant parts of your vehicle. After a fall or collision,
check the product and if there is the lightest indication of damage, you must completely replace it.
Some products require registration.
These products have been designed for a standard vehicle. ABM® Fahrzeugtechnik GmbH makes no
warranty or guarantee of any kind for any damages whatsoever arising out of the combination with
other component parts not tested by ABM, as a consequence of improper installation or inadequate
maintenance.
Brake fluid may damage painted surfaces and fairings. Use suitable means to protect all of the surfaces
against damage.
1
Preparation
Before coating, the fender must be fitted and adjusted, where necessary.
Please read the entire safety information and installation manual carefully.
A motorcycle not securely positioned can fall over during the following work. Therefore, make sure
that the motorbike is positioned on solid, flat ground and is secured against falling over and rolling
away.
Keep children and pets away from the work area.
Protect removed parts from damage.
When disassembling individual parts, please note which screws are used to fasten them. Keep these
parts and screws and unless specified otherwise, reuse when assembling.

Installation manual for Fender
• Revision: 00 • 27/10/2021 • © ABM Fahrzeugtechnik GmbH Page 3 of 4
2
Content:
3
Installation:
Make sure that the motorbike is securely positioned.
Loosen the four screws of the original fender.

Installation manual for Fender
• Revision: 00 • 27/10/2021 • © ABM Fahrzeugtechnik GmbH Page 4 of 4
All wires must be laid in a manner which prevents them from bending or getting pulled during spring
deflection movements and which adequately protects them against rubbing.
After completing the work, check that all components and screws are tight and functioning correctly. Also
check the rear wheel's freewheel and the functionality of the brake system.
Afterwards, a test drive must be carried out! After completing the test drive, the tightness of all screw
connections must be checked, as well as the adequate free travel of all moving parts. Re-test the rear
wheel's freewheel and check the brake system for overheating.
Remove the fender carefully.
Position the new fender carefully. Align the short side to
the front.
Push the four screws provided through the fork and the
fender.
Align the fender and tighten it with the washers and nuts
provided.
Tightening torque 12 Nm
4
Final check