Wunderkind Custom LittleOne Original instructions

• www.wunderkind-custom.com ••• [e-mail] •
Installation and safety information
LED indicator littleOne

Installation manual for LED indicator littleOne
• Revision: 00 • 23/11/2017 • © ABM Fahrzeugtechnik GmbH Page 2 of 3
Caution
Important safety advice:
Working on motorcycles poses a safety risk. Some work may only be carried out by appropriately
qualified personnel. Faulty work can have serious consequences and may pose a threat to life and
health. Only undertake installation works if you are sufficiently qualified and have an official workshop
manual as well as all relevant service notifications available. Otherwise, we strongly recommend that
the installation is carried out or at least checked in a specialist workshop.
Any work in relation to the installation, removal and tightening torque of original parts should always
be carried out in compliance with the workshop manual.
All screws must be attached with thread-locking fluid. However, this should only be done after the
installation is complete.
It is your responsibility to check the product regularly and to determine if a service or replacement is
required.
Please bear in mind that some products are safety-relevant parts of your vehicle. After a fall or collision,
check the product and if there is the slightest indication of damage, you must replace it.
Some products require registration.
These products have been designed for a standard vehicle. ABM® Fahrzeugtechnik GmbH makes no
warranty or guarantee of any kind for any damages whatsoever arising out of the combination with
other component parts not tested by ABM, as a consequence of improper installation or inadequate
maintenance.
Brake fluid may damage painted surfaces and fairings. Use suitable means to protect all of the surfaces
against damage.
Please read the entire safety information and installation manual carefully.
A motorcycle not securely positioned can fall over during the following work. Therefore, make sure
that the motorbike is positioned on solid, flat ground and is secured against falling over and rolling
away.
Keep children and pets away from the work area.
Protect removed parts from damage.
Please note when disassembling individual parts which screws are used to fasten them. Keep these
parts and screws and unless specified otherwise, reuse when assembling.

Installation manual for LED indicator littleOne
• Revision: 00 • 23/11/2017 • © ABM Fahrzeugtechnik GmbH Page 3 of 3
1) The battery must be disconnected before installation.
2) Clean the surface (free from dust and grease).
3) Stick the indicator onto the cleaned surface using the adhesive tape provided. When
doing this, firmly press the housing down on the entire surface for at least 10
seconds. Do not put pressure on the adhesion for at least 24 hours. Processing
temperature 15°-25°.
(The lighting direction must be aligned so that it is parallel to the road).
4) Cover the cable with heat-shrink tubing (do not bend).
5) Connect indicator with the solder connection
Yellow cable (indicator) to plus (+)
Black cable (indicator) to earth (–)
6) Check proper function
Notes:
If the flashing frequency is too high, resistors can either be connected parallel to the
indicator or a load-independent indicator relay can be used.
In case of vehicles with CAN bus system or ABS, error messages can occur due to the
lower electrical resistance of the LED indicator. In this case, it is remedied by a
resistor connected in parallel.
CAUTION:
After installation, the proper functioning of the
vehicle, including ABS and CAN bus, must be verified!
Installation: