Wyndham Collection WC-4141-84-DBL User manual

Installation Guide
WC-4141-84-DBL
0
1
234
HOW TO ADJUST HINGES (if required)
REQUIRED TOOLS NOT IN BOX
Phillips Screwdriver
Spirit Level
Silicone sealant
(Not all components may be included, depending upon your purchase)
●
●
●
PACKING LIST
Main Cabinet / 1
Mirror / 1 (may not be
included)
Screws for mirror / 2 (may
not be included)
Professional installation recommended.
●Please install on a level surface. If minor
door and drawer alignment is required,
please follow the easy directions below.
Protect all surfaces from sharp objects,
high heat sources, direct prolonged
sunlight and chemical hazards.
Prior to installation please check received
items against the “Packing List”.
Please report any missing items to your
retailer immediately.
Counter & Sink / 1 (may
not be included)
adjust depthadjust laterallyadjust heightremoveinstall
Tape measure Pencil Electric Drill
●Backsplash comes in two pieces.

Installation Guide
WC-4141-84-DBL
INSTALLATION INSTRUCTIONS
Short screws are for the door handles and long screws are
for the drawer handles.
3
Short, for door handles Long, for drawer handles
Unpack the handles and install them on the vanity. Do not
over tighten when attaching.
2
Install the counter. Seal around the top of the cabinet with
clear silicone sealant. Do not over apply. Allow to dry 24
hours for proper curing.
4
1
The handles are safely stored for transport in a box inside
of the cabinet. Look inside the vanity for the box with your
handles.

Installation Guide
WC-4141-84-DBL
HOW TO ADJUST DRAWER SLIDES (if required)
Up and Down Adjustment
6-8mm
Install the screws into the wall anchors, leaving enough of
the screw exposed to hang the mirror - approx 1/4” - 1/2”.
6
Mark the screw position
Diameter 6mm
Depth 40 mm
Draw horizontal line
Install the mirror: use a pencil to mark the placement of the
screw holes on the wall, drill the holes and insert the plastic
wall anchors.
5

Installation Guide
WC-4141-84-DBL
Side Adjustment
Depth Adjustment
Scan the QR code with your phone to watch detailed video
instructions or visit www.wyndhamcollection.com/3dslides

Installation Guide
WC-4141-84-DBL
Easy to install
Long 5 foot plug in cord
2 electrical outlets, 125V 15A
Tamper Resistant (TR) outlets
Power reset switch
2 USB ports, 5V 2.1A Max
Use with ground-fault circuit interrupter (GFCI) outlets only
Residential use only
Follow all applicable electrical codes
ETL Listed
Conforms to UL Standard 962A
Certied to CAN/CSA Standard C22.2 No. 308
*Note: All measurements are ± 1/4”.
Electrical Outlets with Charging Hub
Backboard Cutouts
8-1/4"
20"
27-1/2"
7-1/2"
15"
3"
2-1/4"
79-1/2"
34-1/4"
11-3/4"