Wyndham Collection WC-WHE007-SH-60 User manual

WC-WHE007-SH-60
Installation Guide
Prior to installation please check received items against the “Packing
List”. Please report any missing items to your retailer immediately.
Protect all surfaces from sharp objects, high heat sources, direct
prolonged sunlight and chemical hazards. Put soft material like a
blanket on the ground to avoid scratching the cabinets or floor.
Professional installation recommended.
PACKING LIST
(Not all components may be included, depending upon your purchase)
0
1
234
12300mm
"-
CHN
REQUIRED TOOLS NOT IN BOX
Tape measure Pencil Electric Drill Phillips Screwdriver Adjustable Wrench Spirit Level Silicone sealant
adjust laterally adjust depth
adjust height
HOW TO ADJUST HINGES
Sinks / 2 Main Cabinet / 1 Countertop / 1 Medicine Cabinet / 1 set

WC-WHE007-SH-60
Installation Guide
(1)
(2)
(3)
CABINET ASSEMBLY
1) Mark the screw hole positions on the wall with pencil, refer to the drawing below. Drill the
holes. Using stud bolts, drill through the cabinets into studs. Stud bolts are not included.
2) Carefully place the counter on the cabinet and then install the sinks.
3) Unscrew handles inside and reattach outside.

WC-WHE007-SH-60
Installation Guide
12 12
(1)
(2)
13
3-3)
3-2)3-1)
3-4)
MIRROR CABINET ASSEMBLY
1) Mark the screw hole positions on the wall with pencil, refer to the drawing below. Drill the
holes and screw in the expanding screws.
2) Screw the cabinet in through the holes. Cover the screws using the screw covers.
3-1) Screw the brackets into the holes on the shelf backings.
3-2) Put the glass shelves into the brackets.
3-3) Tighten the screws.
3-4) Wipe clean.

WC-WHE007-SH-60
Installation Guide
4 5
6
(1)
(2)
6-8mm
4) Mark the screw hole positions on the wall with pencil, refer to the drawing below. Drill the
holes and tap in expanding screws and then screws, leaving about 1/4” of the screw stem out.
5) Hang the shelf to the screw stem, refer to the drawing below.
6) Wipe clean.

WC-WHE007-SH-60
Installation Guide
1
2
3
4
5
6
7
8
7
11
9
10
7
8
DRAIN ASSEMBLY
Connect trap to drain assembly as shown below,
hand tighten and check for alignment. It may be
necessary to cut off part of the vertical or the
horizontal leg in order to make everything fit
properly with existing plumbing.
Install P-trap ensuring all the gaskets are in
place and tighten.
1 Basin
2 Pop-up
3 Top gasket
4 Bottom lip gasket
5 Gasket
6 Washer
7 Bottom gasket
8 Drain nut
9 Rubber pipe
10 Tail piece
11 Drain lid
Drawings are not to scale