Xerox PHASER 340 Manual

MovingYour Printer
Before turning off the printer, wait for it to display the Ready message.
Turn off the printer using the rear-panel
On/Off switch.
Caution To avoid damaging the printer, let the printer cool down for at
least 30 minutes before you move it so that the ink has time to
solidify.
Before you move the printer, you’ll want to complete the steps on removing
the maintenance tray and locking the transit restraint.
Removing the maintenance tray
1. Remove the maintenance tray from the printer, keeping it level.
Remove, empty, and replace the waste tray. Refer to the
information on the maintenance tray if you need detailed
instructions.
2. Place the maintenance tray in a plastic bag and seal the bag.
The maintenance tray contains drum fluid that leaks if the tray is
tipped. Keep the maintenance tray level and in a sealed plastic
bag while transporting it.
Caution To avoid damaging your printer and invalidating your
printer’s warranty, remove the maintenance tray before
moving the printer. Always store a used maintenance tray in a
leak-proof package. When handling the maintenance tray, keep
it level. Never ship a partially used maintenance tray. Contact
with the drum fluid poses no known health risk.

Locking the transit restraint
Refer to the following illustration while performing these steps.
1. When the printer displays the Ready message, power it down
using the rear-panel
On/Off switch. The printer places the print
head in the locking position.
Caution To avoid damaging the printer’s internal components, always
turn the printer power off and lock the transit restraint before
moving the printer. Failure to do so may result in damage to
the printers’ internal components and may invalidate your
printer’s warranty.
2. Locate the transit restraint on the right side of the printer and
insert a wide flat-blade screwdriver into the transit restraint slot.
9101-51
2
3

3. While pressing inward with medium pressure, turn the transit
restraint slot in a
clockwise direction to lock the print head in
position. The lock button is recessed from the side of the printer
when fully engaged.
Source: 070-9101-03 AC