Xerox Phaser 7750 User manual

Phaser® 7750 Color Laser Printer
Copyright © 2004 Xerox Corporation. All Rights Reserved.
2-2
Changing Paper
The paper trays adjust to accommodate most sizes and types of paper, transparencies, or other
specialty media. For best results, use only Xerox Phaser Color Printing Media specified for
this printer. They are guaranteed to produce excellent results on your Phaser 7750 Printer – the
Phaser 7750 and Phaser media are Made for Each Other. See “Basic Printing” later in this
section for instructions on how to load paper in the trays.
Caution
If you change the type or size of paper in a tray, you must change the paper type and size
on the front panel to match the paper that you loaded. If you fail to do this, print-quality
problems or jams can occur, and the fuser can be damaged.
Guidelines
After loading a tray and adjusting the paper guides, set the correct paper type and size at the
printer’s front panel.
■Do not overload the paper tray. See the tray label for the fill line.
■Fan paper, transparencies, or other specialty media before loading in the paper tray.
■If excessive jams occur, use fresh paper, transparencies, or other specialty media from a
new package.
Caution
Damage caused by using unsupported paper, transparencies, and other specialty media is
not covered by the Xerox warranty, service agreement, or Total Satisfaction Guarantee.
The Total Satisfaction Guarantee is available in the United States and Canada. Coverage
may vary outside these areas; please contact your local representative for details.
Note
For optimal print quality and performance, set the correct paper type at the printer's front
panel after loading paper in any tray. When loading paper in Tray 1 (MPT) or Tray 2, also
set the correct paper size.
Load paper in the trays either long-edge feed or short-edge feed. See the Supported Papers,
Transparencies, and Other Specialty Media tables on the following pages to identify paper
feed directions for each paper size and paper tray.

Changing Paper
Phaser® 7750 Color Laser Printer
2-3
1. Load paper in the tray.
Note
Do not load paper above the fill line inside the tray.
2. When prompted by the printer’s front panel, select one of the following options to confirm
or change the paper type and size:
Tray 1 (MPT) and Tray 2
:
■Press the OK button to confirm the paper type and size.
■Select Change, then press the OK button. Press the Up Arrow or Down Arrow
button to select the appropriate paper type, then press the OK button. Press the Up
Arrow or Down Arrow button to select the appropriate paper size option, then press
the OK button.
Tray 1 (MPT)
Tray 1 (MPT) Long-Edge Feed Tray 1 (MPT) Short-Edge Feed
Trays 2-5
Trays 2-5 Long-Edge Feed Trays 2-5 Short-Edge Feed
7750-149
MAX
7750-150
MAX
7750-151
7750-152

Changing Paper
Phaser® 7750 Color Laser Printer
2-4
Trays 3-5
■Press the OK button to confirm the paper type.
■Press the Up Arrow or Down Arrow button to select a different paper type, then press
the OK button.
For online support information, go to www.xerox.com/office/infoSMART.
7750-154
Confirm Tray 1 (MPT) Paper
OK: Letter (8.5 x 11.0 in.) Plain
Paper
Change
Phaser 7750
7750-170
Confirm Tray 2 Paper
OK: Letter (8.5 x 11.0 in.) Plain
Paper
Change
Phaser 7750
7750-153
Confirm Tray N Paper
Plain Paper
Heavy Plain Paper
Thin Card Stock
Letterhead
Exit
Phaser 7750