Xerox PHASER 6250 Guide

Phaser® 6250 Color Laser Printer
Copyright © 2003 Xerox Corporation. All Rights Reserved.
4-20
Maintenance
This topic includes:
■"Cleaning the Outside of the Printer" on page 4-20
■"Cleaning the Density Sensor" on page 4-21
For safety information, go to Reference/Troubleshooting/User Safety on the User
Documentation CD-ROM.
Your printer needs little maintenance to keep it producing quality prints. Certain routine
maintenance items need to be ordered occasionally:
■Toner Cartridges (Cyan, Yellow, Magenta, and Black)
■Imaging Unit
■Fuser
■Transfer Roller
■Feed Roller Kit
Access the “Supplies Usage Page” from the printer’s front panel, from CentreWare IS, or print
the “Usage Profile” at the printer’s front panel.
Caution
If you attempt to use a non-Xerox toner cartridge, it may not fit properly into the printer. If
the cartridge does not fit properly, the printer will be unable to function.
Order extra printer supplies when the printer’s front panel displays a warning that the supply is
low or near the end of its life. You must replace the supply when the front panel displays an
error message that the supply is empty or at the end of its life.
For information about supplies, go to www.xerox.com/officeprinting/6250supplies. Each
supply includes installation instructions with the packaging.
Cleaning the Outside of the Printer
You can clean the outside of the printer with a soft, damp, cloth. You can use a cloth moistened
with a mild neutral detergent to remove stains; do not spray detergent directly onto the printer.
Warning
To prevent electric shock, turn the printer off and unplug the power cord from the
electrical outlet before cleaning the printer.
Do not use a vacuum cleaner to clean the printer. Do not lubricate the printer with oil.

Maintenance
Phaser® 6250 Color Laser Printer
4-21
Cleaning the Density Sensor
The printer has stopped printing because the density sensor is dirty. To clean it:
1. Push up the latch on the front of the printer to open Front Door A.
2. Remove the transfer roller. Squeeze together the orange tabs at both sides of the transfer
roller and gently lift it out of the printer.
Caution
Avoid touching the surface of the roller.
6250-066
6200-023

Maintenance
Phaser® 6250 Color Laser Printer
4-22
3. Use a dry towel or cotton swab to clean the density sensor.
Caution
Do not use isopropyl alcohol or canned air on the sensor.
4. Reinstall the transfer roller. Insert the rounded ends of the transfer roller into the curved
black guides inside the printer. Lock the transfer roller into the printer by pushing down on
the orange tabs until you hear a click.
5. Close Front Door A.
6250-01
2
6200-024
6250-094